HP 4250/4350 Sleep Delay, To set the printer default for PS Defer Media, To set Size/type prompt

To set the printer default for PS Defer Media

1.Press MENU to open the menus.

2.Press (DOWN button) to highlight CONFIGURE DEVICE.

3.Press (SELECT button) to select CONFIGURE DEVICE.

4.Press (DOWN button) to highlight SYSTEM SETUP.

5.Press (SELECT button) to select SYSTEM SETUP.

6.Press (DOWN button) to highlight TRAY BEHAVIOR.

7.Press (SELECT button) to select TRAY BEHAVIOR.

8.Press (SELECT button) to select PS DEFER MEDIA.

9.Press (UP button) or (DOWN button) to select ENABLED or DISABLED.

10.Press (SELECT button) to set the behavior.

11.Press MENU to exit the menu.

To set Size/type prompt
1.	Press MENU to open the menus.
2.	Press	(DOWN button) to highlight CONFIGURE DEVICE.
3.	Press	(SELECT button) to select CONFIGURE DEVICE.
4.	Press	(DOWN button) to highlight SYSTEM SETUP.
5.	Press	(SELECT button) to select SYSTEM SETUP.
6.	Press	(DOWN button) to highlight TRAY BEHAVIOR.
7.	Press	(SELECT button) to select TRAY BEHAVIOR.
8.	Press	(SELECT button) to select SIZE/TYPE PROMPT.
9.	Press	(UP button) or (DOWN button) to select DISPLAY or DO NOT DISPLAY.
10.	Press	(SELECT button) to set the behavior.
11.	Press MENU to exit the menu.

	Sleep Delay
	The adjustable Sleep Delay feature reduces power consumption when the printer has been
	inactive for an extended period. You can set the length of time before the printer goes into
	sleep mode to 1 MINUTE, 15 MINUTES, 30 MINUTES, or to 60 MINUTES, 90 MINUTES, 2
	HOURS, or 4 HOURS. The default setting is 30 MINUTES.
	The printer control-panel display dims when the printer is in sleep mode. Sleep mode does
NOTE
	not affect printer warm-up time unless the printer was in sleep mode for more than 8 hours.

ENWW Control panel 19