HP 4250/4350 manual Printing on paper that has a special finish

Printing on paper that has a special finish

Some paper has a special finish, such as laid paper, bond paper, and cockled paper. These types of paper can cause issues in regard to toner adhesion and print quality. Follow these guidelines when printing on paper that has a special finish.

●At the printer control panel, open the CONFIGURE DEVICE menu. On the PRINT QUALITY submenu, select FUSER MODES, and then select the paper type that you are using (such as BOND). Set the fuser mode to HIGH 1 or HIGH 2. HIGH 2 provides better toner adhesion and optimal print quality for paper that has a highly textured finish. Open the PAPER HANDLING menu and set TRAY TYPE to the type of paper that you are using (such as BOND) to turn on the appropriate fuser mode.

NOTE	The printer might print at a slower speed when set at HIGH 1 or HIGH 2. Use the HIGH 1
	and HIGH 2 settings only if you are experiencing toner-adhesion problems. The HIGH 1 and
	HIGH 2 settings might increase problems with curl and jams.
	● Some makers of these types of paper are now coating one side of the paper to enhance
	toner adhesion and print quality. To take advantage of this feature, make sure to load
	the paper correctly. The side on which you can read the watermark correctly is the front
	side, or the side to be printed on.
	For tray 1, load paper with the front side facing up, and the top, short edge toward the printer.

For tray 2, optional 500-sheet trays, and the optional 1,500-sheet tray, load paper with the front side facing down, and the top, short edge toward you.

ENWW Printing on special media 67