To set the job storage limit

1.Press MENU to open the menus.

2.Press (DOWN button) to highlight CONFIGURE DEVICE.

3.Press (SELECT button) to select CONFIGURE DEVICE.

4.Press (DOWN button) to highlight SYSTEM SETUP.

5.Press (SELECT button) to select SYSTEM SETUP.

6.Press (SELECT button) to select JOB STORAGE LIMIT.

7.Press (UP button) or (DOWN button) to change the value.

8.Press (SELECT button) to set the value.

9.Press MENU to exit the menu.

Job held timeout

This option sets the period of time that the system keeps files in job storage before deleting them from the queue. The default setting for this option is OFF; the other available settings are 1 HOUR, 4 HOURS, 1 DAY, and 1 WEEK.

NOTE

This option is only available if a hard drive is installed.

To set the job held timeout

1.Press MENU to open the menus.

2.Press (DOWN button) to highlight CONFIGURE DEVICE.

3.Press (SELECT button) to select CONFIGURE DEVICE.

4.Press (DOWN button) to highlight SYSTEM SETUP.

5.Press (SELECT button) to select SYSTEM SETUP.

6.Press (DOWN button) to highlight JOB HELD TIMEOUT.

7.Press (SELECT button) to select JOB HELD TIMEOUT.

8.Press (UP button) or (DOWN button) to select the appropriate time period.

9.Press (SELECT button) to set the time period.

10.Press MENU to exit the menu.

Show address

This item determines whether the printer's IP address appears on the display with the Ready message. If more than one EIO card is installed, the IP address of the card that is installed in the first slot appears.

16 Chapter 1 Printer basics

ENWW

Page 28
Image 28
HP 4250/4350 manual Job held timeout, Show address, To set the job storage limit, To set the job held timeout