HP 4250/4350 manual Language, To set the jam-recovery response, To set the RAM disk

To set the jam-recovery response

1.Press MENU to open the menus.

2.Press (DOWN button) to highlight CONFIGURE DEVICE.

3.Press (SELECT button) to select CONFIGURE DEVICE.

4.Press (DOWN button) to highlight SYSTEM SETUP.

5.Press (SELECT button) to select SYSTEM SETUP.

6.Press (DOWN button) to highlight JAM RECOVERY.

7.Press (SELECT button) to select JAM RECOVERY.

8.Press (UP button) or (DOWN button) to select the appropriate setting.

9.Press (SELECT button) to set the selection.

10.Press MENU to exit the menu.

RAM disk

This option determines how the RAM disk feature is configured. This option is only available if no hard disk is installed and the printer has at least 8 MB of free memory. The default is AUTO.

●AUTO. The printer determines the optimal RAM disk size based on the amount of available memory.

●OFF. The RAM disk is disabled, but a minimal RAM disk is still active (sufficient to scan one page).

To set the RAM disk

1.Press MENU to open the menus.

2.Press (DOWN button) to highlight CONFIGURE DEVICE.

3.Press (SELECT button) to select CONFIGURE DEVICE.

4.Press (DOWN button) to highlight SYSTEM SETUP.

5.Press (SELECT button) to select SYSTEM SETUP.

6.Press (DOWN button) to highlight RAM DISK.

7.Press (SELECT button) to select RAM DISK.

8.Press (UP button) or (DOWN button) to select the appropriate setting.

9.Press (SELECT button) to set the selection.

10.Press MENU to exit the menu.

Language

If LANGUAGE appears in English on the control panel, use the following procedure. Otherwise, turn the printer off and then on again. When XXX MB appears, press and hold (SELECT button). When all three control panel lights are lit, release (SELECT button) and use the following procedure to set the language.

24 Chapter 1 Printer basics ENWW