HP 4250/4350 NON HP Supply Installed, Current status message Description, Output Paper Path Open

Interpreting control-panel messages (continued)

Control panel message No job to cancel

NON HP SUPPLY INSTALLED Economode disabled

NON HP SUPPLY

INSTALLED

For help press

ORDER CARTRIDGE LESS THAN XXXX PAGES For help press

alternates with

<current status message>

Description

The STOP button was pressed, but there is no active job or buffered data to cancel.

The message is displayed for approximately 2 seconds before the printer returns to the ready state.

The printer has detected that the print cartridge is not a genuine HP supply.

The printer has detected that the print cartridge is not a genuine HP supply.

For the HP LaserJet 4250 series, the message first appears when about 15% (10,000-page cartridge) or about 8% (20,000-page cartridge) of the life remains in the print cartridge. For the HP LaserJet 4350 series, the message first appears when about 25% (10,000- page cartridge) or about 15% (20,000- page cartridge) of the life remains in the print cartridge.

Recommended action

No action necessary.

This message is displayed until you install an HP cartridge or press the override button (SELECT button).

If you believe you purchased a genuine HP supply, go to http://www.hp.com/go/ anticounterfeit.

Any printer repair required as a result of using non-HP supplies or unauthorized supplies is not covered under the printer warranty.

This message is displayed until you install an HP cartridge or press the override button (SELECT button).

If you believe you purchased a genuine HP supply, go to http://www.hp.com/go/ anticounterfeit.

Any printer repair required as a result of using non-HP supplies or unauthorized supplies is not covered under the printer warranty.

Make sure that you have a new cartridge ready (see Ordering parts, accessories, and supplies).

OUTPUT PAPER PATH OPEN

For help press

Paused

To return to ready press STOP

The paper path between the printer and the output device is open and must be closed before printing can continue.

The printer is paused but continues to receive data until the memory is full. The printer is not experiencing an error.

1.Make sure the jam-access door on the optional stacker or stapler/ stacker is closed.

2.If the accessory is a stapler/stacker, make sure that the stapler unit is snapped into the closed position.

Press STOP.

ENWW Understanding printer messages 163