HP 4250/4350 manual System Setup submenu, Toner, To 5 *3, Density Small Paper Mode *NORMAL Slow

Item	Values
TONER	1 to 5 (*3)
DENSITY

SMALL PAPER MODE *NORMAL SLOW

Explanation

Lighten or darken the print on the page by setting the toner density. Select a setting ranging from 1 (light) to 5 (dark). The default setting of 3 usually produces the best results.

NOTE

It is best to change the toner density in the program or printer driver. (Program and printer driver settings override control-panel settings.)

Select SLOW to prevent jams when printing on narrow media, as the part of the fuser rollers that do not make contact with the media swell up, which can cause wrinkles.

AUTO

CLEANING

CLEANING

INTERVAL

AUTO CLEANING SIZE

CREATE CLEANING PAGE

PROCESS CLEANING PAGE

*OFF

ON

1000*

2000

5000

10000

20000

*LETTER

A4

There is no value to select.

There is no value to select.

Clean the fuser automatically by using this feature. This setting is unavailable if an optional duplexer is installed. If a duplexer is installed, run the cleaning page manually. See CREATE CLEANING PAGE below and Cleaning the fuser.

If auto cleaning is on, set how often it runs. The intervals correspond to the number of pages that the printer has printed. This setting is unavailable if an optional duplexer is installed.

If auto cleaning is on, set the size of paper that the printer should use when it is cleaning the printer automatically. This setting is unavailable if an optional duplexer is installed.

Press (SELECT button) to print a cleaning page manually (for cleaning toner from the fuser). Open the rear output bin. Follow the instructions on the cleaning page. For more information, see Cleaning the fuser.

This item is available only after a cleaning page has been created. Follow the instructions that are printed on the cleaning page. The cleaning process might take up to 2.5 minutes.

System Setup submenu

Items on this menu affect printer behavior. Configure the printer according to your printing needs.

The section that follows lists the settings and possible values. In the Values column, the default value for each setting is the one with an asterisk (*) next to it.

220 Appendix B Control panel menus ENWW