D-Link DSL-300G+ manual Trademarks, Copyright Statement

Page 4

DSL-300G+ ADSL Modem User’s Guide

LIMITATION OF LIABILITY

IN NO EVENT WILL D-LINK BE LIABLE FOR ANY DAMAGES, INCLUDING LOSS OF DATA, LOSS OF PROFITS, COST OF COVER OR OTHER INCIDENTAL, CONSEQUENTIAL OR INDIRECT DAMAGES ARISING OUT THE INSTALLATION, MAINTENANCE, USE, PERFORMANCE, FAILURE OR INTERRUPTION OF A D- LINK PRODUCT, HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY. THIS LIMITATION WILL APPLY EVEN IF D-LINK HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGE.

IF YOU PURCHASED A D-LINK PRODUCT IN THE UNITED STATES, SOME STATES DO NOT ALLOW THE LIMITATION OR EXCLUSION OF LIABILITY FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES, SO THE ABOVE LIMITATION MAY NOT APPLY TO YOU.

Trademarks

Copyright 2000 D-Link Corporation.

Contents subject to change without prior notice.

D-Link is a registered trademark of D-Link Corporation/D-Link Systems, Inc.

All other trademarks belong to their respective proprietors.

Copyright Statement

No part of this publication may be reproduced in any form or by any means or used to make any derivative such as translation, transformation, or adaptation without permission from D-Link Corporation/D-Link Systems Inc., as stipulated by the United States Copyright Act of 1976

FCC Warning

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

-Reorient or relocate the receiving antenna.

-Increase the separation between the equipment and receiver.

-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

-Consult the dealer or an experienced radio/TV technician for help.

iv

Page 3 Page 5
Image 4
Page 3 Page 5
Contents DSL-300G+ Adsl Modem User’s Guide Wichtige Sicherheitshinweise Limited WarrantyHardware Link Offices for Registration and Warranty Service SoftwareTrademarks Copyright StatementContents Figures About This User’s Guide Requirements for InstallationBefore You Start Account Information User Name and Password Ethernet Adapter NICConnection Type Bridged Ethernet Connections RFCAdditional Settings IPoA Connections RFCPage Modem Features IntroductionModem Description and Operation Adsl TechnologyLED Indicators Front PanelRear Panel Packing ListHardware Installation Power On ModemConnecting One Computer to the Modem Connecting a Local Ethernet Network to the ModemDSL-300 Adsl Modem User’s Guide First Time Set Up Configuring Your Computer for DhcpConfigure Windows XP for Dhcp DSL-300 Adsl Modem User’s Guide DSL-300 Adsl Modem User’s Guide Configure Windows 2000 for Dhcp WindowsWindows ME Configure Windows ME for DhcpWindows 95 Configure Windows NT 4.0 for Dhcp Configure Windows 95, 98 for DhcpWindows NT 4.0 workstations Access the Web-based Configuration Manager Account Configuration Menu First Time Set UpConfigure the Internet Connection PPPoE ConnectionsChanging the Connection Type Changing Connection TypePPPoA Account Configuration Initial Set Up Change Connection Type to PPPoADSL-300 Adsl Modem User’s Guide IPoA Account Configuration Initial Set Up Change Connection Type to IPoARFC 1483 Bridge Account Configuration Change Connection Type to RFC 1483 BridgeWeb-based Configuration Manager GUI Using the Web ManagerDisconnect Adsl Connection System Setting VPI/VCI Settings AC Name PPPoE onlyPPP Account Configuration PPP InformationIPoA Account Configuration GatewaySummary Summary StatisticsBridge Connection Summary Screen Adsl Line Status Operation PathUpdate Firmware Update Firmware ScreenAccounts Management Accounts ManagementTechnical Specifications Data Transfer RateOffices Norway Link Norway Registration Card Print, type or use block letters
Top Page Image Contents