Motorola Powerline MU manual Number of Splits Maximum dB loss per split Way

Page 29

Powerline MU

∙RG6 Coax cable

∙Coax Splitters (must include 5-30 MHz in range). Number of splits and splitters is determined by the number of cables and locations of coupler installation. If

possible, use bi-directional splitters. A possible source for bi-directional splitters is the Radio Shack® 2-way splitter (Model 15-2587) and the Radio Shack 4-way splitter (Model 15-2588).

Maximum dB Loss Chart

Number of Splits

Maximum dB loss per split

2-way

-3.5

3-way

-5.7

4-way

-7.5

∙Conduit Fittings (compression connectors/setscrew couplings)

∙Cable Ties as needed

∙Rubber Grommets as needed

Procedure

1.Remove the panel of either the termination or distribution cabinets at the desired location.

2.Determine number of couplers needed.

3.Determine the number of bi-directional splitters needed (if feeding multiple cabinets).

4.Remove knock-out or create a small hole in the bottom or side of the cabinet.

5.Install conduit fitting in knock-out.

6.Mount the Gateway in the desired location. Be sure to note the distance between the Gateway location and the location where the couplers will be installed.

7.After determining the length needed, create RG6 coax cable with standard F- Connectors on each end.

8.Attach the F-Connector from one end of the cable to the back of the Gateway as shown in Figure 12.

9.Attach the other F-Connector lead (from coax going to Gateway) to the inbound port on the coax splitter. Attach terminators to any unused ports on the splitter.

10.Feed the coax end of the couplers through the conduit fitting and connect it to the splitter.

11.Open the coupler by gently lifting on the latch on the housing. The housing is hinged on the other side so it remains intact. The core itself will be in half, with one half containing the insulated cable that will induce the RF signal onto the electrical lines.

12.Connect one coupler to each phase in the cabinet, being sure the plastic case latches securely together. Be sure the cable stays inside the core when latching.

Page 29 of 112

Page 28 Page 30
Image 29
Page 28 Page 30
Contents Powerline MU User Guide Trademarks, Product Names, and Service Names Table of Contents Configuring the Powerline MU Gateway List of Figures Sample Diagram a List of Tables Becoming Familiar with this User Guide About this User GuideAdmonition types Getting Additional HelpSending Feedback Send e-mail to technical-support@canopywireless.comOverview of Powerline MU Security Powerline MU FeaturesNetwork Operations Bandwidth ManagementOrdering Equipment Plug Types Powerline MU ProductsPowerline MU Canopy WirelessEthernet from SM to Gateway Connecting the Canopy Network to the GatewayMain Planning Building Electrical ConsiderationsOwners of Electrical Equipment Gateway LocationInstalling Powerline MU Electrical Symbols Sample Diagram B TWO-PHASE SINGLE-PHASE Installation Two-phase installation THREE-PHASE InstallationMass Metered Mass-metered installationWiring the Panel Extender Using a Panel Extender multiple electrical panelsIndividually Metered Inductive Coupling Installation Diagram Inductive Coupler Connection, One Transformer Powerline MU Inductive Coupler 750 available Q4 Number of Splits Maximum dB loss per split Way Multiple Transformer Inductive Coupler Connection, Multiple Transformers Individually-metered installation capacitive coupling Equipment Staging Upgrading FirmwareMount the Gateway InstallationInstall Modems Connect to the Gateway Configuring the Powerline MU GatewayUser Interface Navigation tips Date and Time Configuration and MaintenanceSystem Information System Password Configuration Screen System Password ConfigurationLogs Screen LogsReboot and Reset to Defaults Screen RebootSite Info Backup and Restore SettingsAdvanced BAM ConfigurationSnmp Configuration Snmp ConfigurationPLV-GATEWAY-MIB Vlan Configuration Snmp Access ControlAn Example Network Configuration for Vlan Implementation Example of Vlan Configuration Screen in the Gateway Example Configuration of a Modem in Vlan Pass-Through Mode Modem Luid Range Configuration in the Powerline MU Gateway IP Address IP ConfigurationModem List PowerlineNEK Configuration NEK ConfigurationPSD Setting PSD SettingPowerline MU Carriers Linked to Carrier Frequency Remote NEK Modem NEK Screen Powerline ModemPage Connect to the Modem Powerline ModemConfiguring the Powerline Modem Powerline Modem Screen MAPSystem Info Screen System InfoSystem Password Screen System PasswordSystem Logs Screen System LogsReset Screen ResetBackup Screen BackupSite Info Advanced Packet Priority Advanced Packet PriorityAdvanced Bandwidth Control Advanced Bandwidth ControlAdvanced Snmp Configuration Advanced Snmp ConfigurationWhispPlvModemAdmWConfigGroup Operating Mode Modem Repeater Function Advanced Snmp Access ControlTypical Set Up for the Modem Repeater Operating Mode Use with Reeater IP Configuration IP Address with NAT Enabled Screen IP Configuration with NAT EnabledIP Address WAN 2 WANIP Address DMZ 3 DMZNetwork Encryption Key Scan DevicesPSD Setting Screen National and Regional Regulatory Notices Important Note on Modifications1 U.S. Federal Communication Commission FCC Notification Declarations of ConformityDeclaration of Conformity Gateway Page Isisis Declaration of Conformity Modem Page 0171486Nxx Model Number Description Declaration of Conformity Hybrid Adapter Issue 0171486N08 Software License Terms and Conditions Legal NoticesIsss Isssiiisis Iisssisiis Siiiiiiis Iiis Hardware Warranty in U.S Limit of Liability Additional Resources History of Changes in This Document Technical Specifications ∙ Ssss Available Now Powerline MU Gateway Issue Powerline MU Panel Extender Available Now Powerline MU Inductive Coupler 500 250 Issue 100 Appendix a International Electric Grid Plug Types Issue 102 Issue 103 Issue 104 Issue 105 Issue 106 Issue 107 Issue 108 Issue 109 Appendix B Signal Distances Issue 111 Issue 112

Powerline MU specifications

The Motorola Powerline MU is a cutting-edge device designed to enhance your home or office internet experience. With growing demands for seamless connectivity, this innovative solution leverages powerline communication technology to deliver high-speed internet access through existing electrical wiring. This means you can utilize your power outlets as network connections without the need to run extensive cabling.

One of the standout features of the Motorola Powerline MU is its impressive data transfer rates. Capable of achieving speeds up to 1000 Mbps, this device ensures that even bandwidth-intensive applications, such as streaming in 4K or online gaming, can be executed smoothly. This high-speed performance is made possible through advanced HomePlug AV2 technology, which optimizes data transfer across the powerline, significantly reducing latency and enhancing overall network efficiency.

Another remarkable characteristic of the Motorola Powerline MU is its plug-and-play simplicity. Setting up the device is straightforward; simply plug it into a wall outlet, connect it to your modem or router via Ethernet, and you’re ready to go. The user-friendly design means you don’t need to be a tech expert to get connected quickly. Additionally, with multiple Ethernet ports available, you can connect several devices simultaneously, providing versatile connectivity options for your home or office.

Security is paramount in today’s digital landscape, and the Motorola Powerline MU does not disappoint in this regard. It features 128-bit AES encryption to ensure that your data remains secure while transmitted over the powerline. This built-in security layer provides peace of mind, allowing users to connect their devices without fearing unauthorized access.

Moreover, the Motorola Powerline MU is environmentally friendly, with power-saving technologies that reduce energy consumption while in use. This aspect aligns with the growing emphasis on sustainability within the technology sector.

In conclusion, the Motorola Powerline MU stands out as an efficient and reliable solution for high-speed internet connectivity via existing electrical infrastructure. With its superior data transfer rates, intuitive setup, robust security features, and energy efficiency, it is an excellent choice for anyone looking to enhance their home or office network experience. The combination of practical design and advanced technology makes the Motorola Powerline MU a noteworthy addition to any modern digital environment.
Top Page Image Contents