Motorola XPR 8300 manual Declaration of Conformity

Page 5

Declaration of Conformity

This declaration is applicable to your radio only if your radio is labeled with the FCC logo shown below.

DECLARATION OF CONFORMITY

Per FCC CFR 47 Part 2 Section 2.1077(a)

Responsible Party Name: Motorola, Inc.

Address: 1301 East Algonquin Road, Schaumburg, IL 60196-1078, U.S.A.

Phone Number: 1-888-567-7347 Hereby declares that the product:

Model Name: XPR 8300 conforms to the following regulations:

FCC Part 15, subpart B, section 15.107(a), 15.107(d) and section 15.109(a)

Class B Digital Device

As a personal computer peripheral, this device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

1.This device may not cause harmful interference, and

2.This device must accept any interference received, including interference that may cause undesired operation.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

iii

Image 5
Contents 6816814H01 Page Foreword Product Safety and RF Exposure CompliancePage Declaration of Conformity Declaration of ConformityPage Table of Contents Chapter Indicators and Connectors Chapter Mechanical InstallationChapter Post-Installation Checklist Chapter AccessoriesRelated Publications List of FiguresList of Figures AA M Repeater Model Numbering SchemeRepeater Model Numbering Scheme Limited Warranty Commercial WarrantyIII. State Law Rights VI. Patent and Software Provisions Xiv Installation Overview Pre-Installation ConsiderationsEnvironmental Conditions at Intended Installation Site Operating Temperature RangeEquipment Ventilation AC Input Power RequirementsEquipment Mounting Methods Air QualityElectrical Ground Site Grounding and Lightning ProtectionRF Ground Lightning GroundPre-Installation Considerations Unpacking Equipment Mechanical InstallationMechanical Installation Front Panel Indicators and ConnectorsLED Indicator Descriptions Rear Panel Part Rear PanelRear Accessory Connector Pin Electrical Connections Power Supply ConnectionsAC Input Power Connection Ground Connection Battery Backup ConnectionAntenna Selection RF Antenna ConnectionsDuplexer Selection Electrical Connections Applying Power Post-Installation ChecklistVerifying Proper Operation ArchivingPost-Installation Checklist Miscellaneous Accessories AccessoriesAntennas CablesAccessories Basic Ordering Information Motorola Online Mail Orders Appendix a Replacement Parts OrderingTelephone Orders Fax OrdersParts Identification Product Customer ServiceMotorola Service Center Appendix B Motorola Service CentersServicing Information Motorola Federal Technical CenterMotorola Service Centers Page 6816814H01