Addtron Technology WebNet manual Component side of the WebRJS-DCE board

Page 10

3.Label with ethernet MAC-address (hardware address)

4.Connector

The status LED’s on the board indicate:

Green Server activity level (“heartbeat”)

Red Internet activity — input/output via the network.

Yellow Network activity — general activity on the attached ethernet.

2.3The WebRJS Adapter Board

The WebRJS adapter board has a component side and a side with the connector for the WebNet DIMM module. The component side is shown on Figure 3, and the numbers indicate the following:

1.RS-232 socket (DB9 female)

2.Reset button

3.Ethernet status LED’s (replicated)

4.Ethernet RJ45 socket

5.Power socket (6,5-7,5V DC)

6.Debug button

Figure 3: The component side of the WebRJS-DCE board

10

WebNet User’s Guide

Image 10
Contents Consulting A/S AprilWebNet User’s Guide Contents WebNet User’s Guide Your ARP table AutoIP Feature References List of Figures Introduction WebRJS module with the WebNet module insertedPage Unpacking Component side of the WebRJS-DCE board WebNet module is being inserted into the WebRJS module Installation WebNet User’s Guide WebNet User’s Guide WebNet home Configuration Dirname WebNet User’s Guide WebNet User’s Guide Configuration page for network settings WebNet User’s Guide Setup page for the Device Sharing service WebNet User’s Guide Monitoring and Statistics Socket Status WebNet User’s Guide WebNet User’s Guide Tools WebNet User’s Guide WebNet User’s Guide Uploading and Running Scripts WebNet User’s Guide WebNet User’s Guide WebNet as an RS232 Gateway WebNet User’s Guide WebNet User’s Guide Example of a WebNet architecture How To Get Started WebNet IP configuration WebNet User’s Guide References References