ADTRAN NetVanta Series manual Create an Octal T1 Multilink Cross-Connect, Save the Configuration

Create an Octal T1 Multilink Cross-Connect

For this example we will configure T1 WAN interfaces with DS0s 1 through 24 for data. The following steps assume the Global Configuration mode is currently active. Verify that the prompt of your unit displays (config)#.

1.Enter interface t1 3/1 to activate the first T1 interface configuration mode on the Octal T1 Wide Module.

2.Enter tdm group 1 timeslots 1-24to create a TDM group for DS0s 1 through 24 on the T1 connections.

3.Enter no shutdown to activate the interface to pass data.

4.Enter cross-connect 2 t1 3/1 1 ppp 2 to connect DS0s 1 through 24 of the T1 network connection (t1 3/1) to the multilink ppp interface labeled 2.

5.Enter interface t1 3/2 to activate the second T1 interface configuration mode on the Octal T1 Wide Module.

6.Enter tdm group 1 timeslots 1-24to create a TDM group for DS0s 1 through 24 on the T1 connections.

7.Enter no shutdown to activate the interface to pass data.

8.Enter cross-connect 3 t1 3/2 1 ppp 2 to connect DS0 1 through 24 of the T1 network connection (t1 3/2) to the multilink ppp interface labeled 2.

9.Repeat the process to configure any additional T1 interfaces needed for your application.

Save the Configuration

1.Verify that the prompt of your unit displays (config)#.

2.Enter exit to leave configuration mode.

3.Enter copy running-configstartup-configto save the current configuration to memory. This command may be abbreviated as copy run start.

4.Enter exit to close the configuration session.

6 Technical Support 1-888-4ADTRAN (1-888-423-8726) 61200890L1-42B