Configure a Telnet Session

The NetVanta Network Interface Modules (NIMs) use a slot/port notation for interface identification. All non-modular interfaces built into the base unit (e.g., the Ethernet port) are identified using 0 as the slot number.

The following steps show how to access the Telnet configuration parameters and change the password. The default password for initializing a Telnet session is password (all lowercase). For security purposes, change the password to something unique. For this example, replace the underlined word with a password of your choosing. The NetVanta supports five Telnet sessions (0 through 4).

1.Enter line telnet 0 to activate the configuration parameters for the Telnet sessions at the (config)# prompt.

2.Enter login to prompt the user for a Telnet access password.

3.Enter password word to create a login password for the Telnet sessions.

4.Enter exit to return to the Global Configuration mode.

An enable security mode password must be defined before configured Telnet sessions are activated. Refer to Set the Enable Security Mode Password for information on password configuration.

Set the Enable Security Mode Password

1.Verify that the prompt of your unit displays (config)#.

2.Enter enable password word to set the Enable Security mode password.

3.Enter enable password md5 word to encrypt the enable password using MD5 encryption.

The Enable Security mode passwords are case sensitive.

Configure the Frame Relay Virtual Interface

The following sections outline configuring a Frame Relay virtual interface (labeled 1) using a single DLCI back to the corporate router (defined as DLCI 16).

The following steps assume the Global Configuration mode is currently active. Verify the prompt of your unit displays (config)#.

61200890L1-42B

Technical Support 1-888-4ADTRAN (1-888-423-8726)