3Com 3CNJ95 manual Appendix F Setting up the Network Cabling at Your Site

Page 43

Appendix F: Setting up the Network Cabling at Your Site

Appendix F: Setting up the Network Cabling at Your Site

The network cabling at your site (from the wiring closet to the wall or cubicle opening) may already be installed. If it is not, install the cabling following these general guidelines.

CAUTION: It is recommended that a professional cable installer perform these procedures. Be sure to adhere to local safety and regulatory codes during the cable installation.

1Connect one end of an Ethernet cable to your network. Usually, this connection is done in a network wiring closet, via the patch panel.

2Terminate the other end of the cable at the location where the NJ95 is being installed using a female RJ-45 connector. Refer to the connector manufacturer’s instructions for terminating the cable. Be sure to test the connector and verify it is working.

To ensure proper horizontal cabling functionality, adhere to the following network cabling standards during installation:

■ANSI/TIA/EIA-568 Commercial Building Telecommunications Cabling Standard

■ANSI/TIA/EIA-569 Commercial Building Standard for Telecommunications Pathways and Spaces

■British Standard Institute (BSI): BS 4664:1970

■DIN

37

Image 43

Contents NJ95 Page User Guide United States Government Legend Contents Page User Guide Package Contents NJ95 Description NJ95 Feature DescriptionNJ95 Main Unit NJ95 Network Jack Main Unit Installing the NJ95 Network JackInstalling the Universal Wall Plate 1a. Installing the Universal wall plateInstalling the Universal Wall Plate with Coupler Cable Installing the Manufacturer-specific Wall Plate 1b. Installing the Manufacturer-specific wall plateConnects the NJ95 to the network Mounting the NJ95 Main unit to the Universal Wall plate 2b. Mounting the NJ95 Main unit to the wall plateGroove for RJ-45 Securing the NJ95 Main unit to the Wall plate 2c. Fastening the NJ95Retaining Screw LED Description Set up the power supplyUnfastening the NJ95 Main unit from the Wall plate Un-Installing the NJ95 Network JackRemoving the NJ95 from the Universal Wall plate Removing the NJ95 from the Manufacturer-specific Wall plate User Guide Appendix a Detail Description of NJ95 Connecting Devices to the NJ95 Wall Plate Dimensions Two hole Appendix B Wall Plate DimensionsWall Plate Dimensions Four hole Appendix C Setting up the Power Supply Using an Integrated Switch with Power over Ethernet Using an Integrated Switch with Power Over EthernetUsing a Multi-port Ethernet Power Supply Using a Multi-port Ethernet Power Supply Using a Single-port Ethernet Power Supply Using a Single-port Ethernet Power SupplyUsing the 3Com Local Power Supply Using the 3Com Local Power SupplyAppendix C Setting up the Power Supply User Guide Network Interface Appendix D SpecificationsPerformance Features User Guide 3CNJPSE Appendix E Obtaining Optional ComponentsUser Guide Appendix F Setting up the Network Cabling at Your Site User Guide Appendix G Troubleshooting the NJ95 Verify that the DIP Switch settings are all set to OFF Online Technical Services Day Free Installation SupportAppendix H Contacting Technical Support User Guide Support from 3Com Support from Your Network SupplierCountry Telephone # Country Telephone # User Guide 3Com Corporation Limited Warranty Limited Warranty and Regulatory Compliance InformationLimited Warranty and Regulatory Compliance Information Warranties EXCLUSIVE, Warranty Disclaimer Governing LAW Industry Canada IC Compliance Statement FCC ComplianceFCC Class a Verification Statement FCC Declaration of ConformityEuropean Union Declaration of Conformity Page 3Com Corporation