3Com 980/000048/001 manual Important Safety Information

Page 3

IMPORTANT SAFETY INFORMATION

WARNING: Warnings contain directions that you must follow for your personal safety. Follow all instructions carefully.

Please read carefully and thoroughly the following information before installing the AccessBuilder 7000 Triple Modem Module:

Exceptional care must be taken during installation and removal of the module.

The safety status of the interconnection ports on this equipment are as follows:

Ports identified by the label PSTN and LEASE = TNV Ports identified by the labels DTE = SELV

TNV (telecoms network voltage) is a circuit which under normal operating conditions carries telecommunication signals.

SELV (safety extra low voltage) is a secondary circuit which is designed and protected so that under normal and single-fault conditions, the voltage between any two accessible parts does not exceed a safe value (42.2 V peak or 60 V DC).

Only connect apparatus complying with the relevant interface requirements to the ports on this unit.

Image 3
Contents Accessbuilder Triple Modem Module User Guide 3Com Corporation 5400 Bayfront Plaza Santa Clara, California Important Safety Information Wichtige Sicherheitshinweise ’INFORMATION DE Sécurité Importante Page Contents Modem Specification and Interface PIN Assignments Index Limited Warranty FCC Class a Verification Statement Page Introduction How to Use This GuideThis table shows where to find specific information About this GuideConventions Icon conventions that are used throughout this guide areText conventions used in this guide are Keep the unit away from radiators and heat sources Additional Safety InformationAbout this Guide Triple Modem Module Support for dial-up transmission protocols Principal FeaturesImplementation of V.32terbo Triple Modem Module Modem Connections To The Central Site Typical ApplicationsRegistering Ownership of your Triple Modem Module Pack Contents ChecklistPre-installation Requirements Triple Modem Module Overview Installation and OperationInstalling The Module Installing The Rear Card Installing the Rear CardExample of Installing a Front Card Installing the Front CardConnecting the Cables Front Panel LEDs Front Panel LEDs Installation and Operation Troubleshooting Troubleshooting GuideModem Health Modem DTE Connection Modem does not accept or echo back AT commandsModem Telephone Line Connection Troubleshooting Perform a local analogue loop test Dial Backup Operation On-line OperationPrivate-line Operation Modem Specification Transmitter / Receiver SpecificationsInterface PIN Assignments Autodial Autoanswer Protocols Physical DescriptionGeneral Approvals Requirements Approvals InformationAll the other apparatus shall comprise only Appendix a Modem Specification and Interface PIN Assignments Ringer Equivalence 21/V.11 DTE Port Pin Assignments24/V.28 35/V.36 Pstn Port Cable Pin Assignments Private Line Port Cable Pin Assignments 3Com Bulletin Board Service On-line Technical ServicesCall the telephone number nearest you World Wide Web SiteSupport from Your Network Supplier Support from 3Com Returning Products for Repair Appendix B Technical Support Numerics IndexSend LED Limited Warranty 408 764-5000 3/18/96 How to Identify and Resolve Radio-TV Interference Problems