Adaptec APA-1350 manual Installing the MiniSCSI

Page 8

MiniSCSI 1350 User’s Guide

Installing the MiniSCSI 1350

Follow the steps below to install the MiniSCSI 1350 and connect your SCSI devices to it. Refer to Figure 1 on page 3 for an illustration of a typical installation.

1Connect the 50-pin interface plug to the SCSI interface socket on your peripheral device.

2Plug the 25-pin interface plug into a parallel-printer connector on your computer.

3Optional: If a printer cable is already attached to the connector, unplug it and connect it to the 25-pin socket on the MiniSCSI 1350.

Note: This is a pass-through printer connection that will allow printing while your SCSI peripheral is in use.

4Ensure that your SCSI peripheral is properly terminated and then switch on power to your SCSI peripheral. The green power indicator on the MiniSCSI 1350 will now be illuminated and you are ready to install the software.

2

Image 8
Contents MiniSCSI Adaptec, Inc South Milpitas Boulevard Milpitas, CA MiniSCSI Parallel Port to Scsi Adapter User’s GuidePage Introduction Page System Requirements Contents of KitIntroduction Installing the MiniSCSI Installing the MiniSCSI Software Installation Windows 95 Software InstallationPrinters Uninstalling the Drivers Windows 95 StandardUnderstanding Scsi Scsi IDsTerminating the Scsi Bus Obtaining Scsi CablesConnector Types Troubleshooting General Hardware TroubleshootingWindows 95 Troubleshooting Can I use Fdisk to prepare my hard disk?Improving Overall Performance Formatting your hard disk drives in Windows Page Contacting Adaptec Electronic SupportTechnical and Product Support Sales and Ordering InformationCopyright Canadian Compliance Statement Adaptec Software License Agreement MiniSCSI 1350 User’s Guide Limited 5-Year Warranty Page