ACTiSYS IR100SLM user manual ACT-IR100SL and IR100SL-M User’s Manual

Page 2

ACT-IR100SL and IR100SL-M User’s Manual

FCC & VCCI Compliance Statement

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

WARNING-FCC Regulations state that any unauthorized changes or modifications to this equipment not expressly approved by the manufacturer could void the user authority to operate this equipment

NOTE: This equipment has been tested and found to comply with the limits for Class B digital device, pursuant to Part 15 of the FCC Rules. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will nor occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

-Increase the separation between the equipment and receiver. -Reorient or relocate the receiving antenna.

-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -Consult the dealer or an experienced radio/TV technician for help.

This equipment is in the 2nd Class category (information equipment to be used in a residential area there to) and conforms to the standards set by the Voluntary Control Council For Interference by Data Processing Equipment and Electronic Office Machines aimed at preventing radio interference in such residential area.

When used near a radio or TV receiver, it may become the cause of radio interference. Read the instructions for correct handling.

NOTE: Must be used with shielded cable only.

FOR YOU RECORDS.....

For your assistance in reporting this product in case of loss or theft, please record below the model number and serial which are located on the bottom of the case. Please retain this information.

Model Number

Serial Number

Date of Purchase

Place of Purchase

All indicated copyrights and trademarks in the following pages are copyrights and trademarks of their Respective corporations.

- 1 -

Version 1.20

 

May 27, 2002

Image 2
Contents ACT-IR100SL-M ACT-IR100SL and IR100SL-M User’s Manual Limited Warranty Precautions Features ACT-IR100SL and IR100SL-M User’s Manual Overview ACT-IR100S-LApplications Embedded IrDA protocol stack SIR IrPHY encoder-decoderACT-IR8200IC-L Blinking LED Baud Rate Setting Ignore DSR Ignore CTSEeprom Function Disable EnableACT-IR100SL and IR100SL-M User’s Manual RS-232C DTE DB-9P Connector Pin No Name DescriptionsHow to Connect IR100S-L/LM with host Device DTE 100M IrDA Printer Adapter ACT-1 IrDA Primary Station Protocol StackII ACT-2 IrDA Secondary Station Protocol Stack 220L/L+ IrDA Com-Port Serial AdapterLimited Warranty Corporation