Connections at the remote module
1Place the remote module adjacent to the user location.
2Attach the lead from the video monitor to the video out socket on the remote module.
D
AD
To video monitor
[MS2 variant only] Optionally attach the lead from a second video monitor to the upper video out socket on the MS2 remote module.
To secondary video monitor
3 Attach the leads of up to four |
|
USB devices (two of which are |
|
usually a keyboard and mouse) |
|
to the sockets located adjacent | D |
to the video output connector. | AD |
To USB devices, |
|
e.g. keyboard, | See the Important note on page 5 |
mouse, etc. |
[MS2 variant only] Note: When connecting four USB devices to the unit, ensure that their total power requirements do not exceed 1700mA (1.7A). The USB standard states a maximum allowable current draw of 500mA (0.5A) per device, although most devices remain well below this limit - USB keyboards and mice typically require 100mA. Each X50 contains a self- resetting fuse that will prevent damage by shutting down the unit if the total power draw becomes excessive.
4[MS2 variant only] Optionally attach
a serial device lead to the male
serial connector on the remote 
module.
To RS232 serial device
operation installation welcome contents