Adder Technology AV Series Connections at the receiver, To connect displays and speakers, Link

Connections at the receiver

To connect displays and speakers

Dual video and audio outputs are provided on the AdderLink AV receiver. Both sets of ports provide identical signals and their connection procedures are the same:

1Attach the video cable from the display module to the socket labelled OUT on the AdderLink AV receiver.

Link in

The link from the transmitter to each receiver module is made using a twisted pair cable, specified to Category 5 or higher.

When a single receiver is attached to a link cable, the maximum length of that link cable is 300 metres (1000 feet).

2Attach the stereo audio cable from the

speakers (or amplifier) to the socket labelled OUT on the AdderLink AV receiver.

SHARP BRIGHT ADSKEWGBDERLINKSKEWRG

OUT

STANDARD LINK

TRANSMITTER RECEIVER

Overall maximum link length: 300m

However, if further receivers are connected in cascade to the initial receiver

OUT 101

REC

(using the LINK OUT port – AdderLink AV101 modules only), then the overall length of the link cables used must be reduced. For further information, please refer to the section Making cascade connections.

NOTE: Where possible, avoid laying the twisted pair link cable(s) alongside power cables.

1 Attach the connector of the link cable to the socket labelled

LINK IN on the AdderLink AV receiver. There should be a		RECEIVER
click when the cable is fully inserted and locked in			101
place.
Note: AV200 transmitters and
receivers must not be connected,
via a CATx link, to AV100,
AV101 or AV104 modules.	LIN
Cascade connections to
	K
	O
	UT

other transmitter types are possible, however, using the video and audio out ports. For further information, please

refer to the section Making cascade connections.



   

13