Advantech PCL-849 manual Default Settings, Interrupt Level IRQ Setting S1, JP1, JP2, JP3, JP4

Page 15

Default Settings

Mode

Enhanced

Mode

Port 1

IRQ12

Address 300H

Port 2

IRQ12

Address 308H

Port 3

IRQ12

Address 310H

Port 4

IRQ12

Address 318H

 

 

 

The following example shows how to set the base address to 2F8.

The switch sum is set to 2F8: 200 + 80 + 40 + 20 + 10 + 8 (HEX).

Note: On the PCL-849 address line A9 does not appear on the DIP switch, as it is permanently hardwired to hex 200.

Interrupt Level (IRQ) Setting (S1, JP1, JP2, JP3, JP4)

The card's IRQ mode can be set using S1. Shared IRQ mode or independent IRQ mode is set as shown below.

1 6

PCL-849 User's Manual

Image 15
Contents PCL-849 Port RS-232 Interface Card Copyright Notice Acknowledgments Contents Introduction Description Specifications Features· Uart Switch and jumper layout Page Hardware Installation Initial Inspection Card Installation Model Setup base address setting Card ConfigurationDefault Settings Address and Interrupt SetupStandardMode Enhanced ModeInterrupt Level IRQ Setting S1, JP1, JP2, JP3, JP4 Default SettingsIndependent IRQ Mode JP1-JP4 Shared IRQ Mode JP1Interrupt Status Register Setup S1, Vector address Interrupt Status Register S1 Bit DIP switch settings for S1 Speed Mode selection Normal Speed ModeHigh Speed Mode Software Installation Icom Utility Setup for Windows 95/98/NT Environments Utility InstallationOperating Environment Selection Board Type PCL-849 ConfigurationVector Address 200H ~ 3F0H Wiring Connector Pin Assignments RS-232 signal wiring RTS CTS GND DSR DTR DCD PC I/O Address Reference PC I/O Address Usage Quick Reference Jumper Setting · IRQ Mode COM1 JP1