Advantech PCL-849 manual Copyright Notice Acknowledgments

Page 2

Copyright Notice

This documentation and the software included with this product are copyrighted 2001 by Advantech Co., Ltd. All rights are reserved. Advantech Co., Ltd. reserves the right to make improvements to the products described in this manual at any time without notice.

No part of this manual or software may be reproduced, copied, translated or transmitted, in any form or by any means without the prior written permission of Advantech Co., Ltd. Information provid- ed in this manual is intended to be accurate and reliable. However, Advantech Co., Ltd. assumes no responsibility for its use, nor for any infringements of rights of third parties which may result from its use.

Acknowledgments

PC-LabCard is a trademark of Advantech Co., Ltd. IBM, PC and PC/XT/AT are trademarks of International Business Machines Corporation. MS-DOS, MASM, QuickBASIC, Microsoft C and MS- PASCAL are trademarks of Microsoft Corporation. Intel is a trade- mark of Intel Corporation. Turbo C and Turbo PASCAL are trade- marks of Borland International.

Part No. 2000084900

3rd Edition

Printed in Taiwan

May 2001

Image 2
Contents PCL-849 Port RS-232 Interface Card Copyright Notice Acknowledgments Contents Introduction Description Features Specifications· Uart Switch and jumper layout Page Hardware Installation Initial Inspection Card Installation Address and Interrupt Setup Card ConfigurationDefault Settings Model Setup base address settingEnhanced Mode StandardModeDefault Settings Interrupt Level IRQ Setting S1, JP1, JP2, JP3, JP4Interrupt Status Register Setup S1, Vector address Independent IRQ Mode JP1-JP4Shared IRQ Mode JP1 Interrupt Status Register S1 Bit DIP switch settings for S1 High Speed Mode Speed Mode selectionNormal Speed Mode Software Installation Operating Environment Selection Icom Utility Setup for Windows 95/98/NT EnvironmentsUtility Installation Configuration Board Type PCL-849Vector Address 200H ~ 3F0H Wiring Connector Pin Assignments RS-232 signal wiring RTS CTS GND DSR DTR DCD PC I/O Address Reference PC I/O Address Usage Quick Reference Jumper Setting · IRQ Mode COM1 JP1