Advantech manual Configuration, Board Type PCL-849

Page 22

Following completion of installation, please restart your system as prompted.

Once the board and driver have been installed and the system restarts successfully, users can execute any ready-made applica- tions, such as HyperTerminal to transmit/receive data, or Remote Access Service to provide dial-up networking capability.

Configuration:

Enter the configuration program to install the device driver, or click the Taskbar [Start] button, then select the [Programs] menu, then the [Advantech Icom Utility] menu and then [Icom].

When the configuration panel pops up,

click the [Add Board] button to add a board.

Click the [Delete] button to remove a board.

Board Type: PCL-849

Base COM: Specifies the COM number of the first port. Subsequent ports are mapped to subsequent COM numbers. For instance, if the first port is mapped to COM10, then the second port is mapped to COM11 sequentially.

Base Address (200H~3F8H): Specifies the base address of the first port. Subsequent base addresses are mapped to subsequent COM numbers. For instance, if the first port is mapped to 300H, then the second port is mapped to 308H sequentially.

PCL-849 series cards can be installed together in a single system as long as the system memory resources are sufficient and available in a system. Different boards should be assigned different IRQs.

Click the [Share IRQ Enable] button to set the share IRQ function.

Chapter 3 Software Installation

23

Image 22
Contents PCL-849 Port RS-232 Interface Card Copyright Notice Acknowledgments Contents Introduction Description Features Specifications· Uart Switch and jumper layout Page Hardware Installation Initial Inspection Card Installation Address and Interrupt Setup Card ConfigurationDefault Settings Model Setup base address settingEnhanced Mode StandardModeDefault Settings Interrupt Level IRQ Setting S1, JP1, JP2, JP3, JP4Shared IRQ Mode JP1 Independent IRQ Mode JP1-JP4Interrupt Status Register Setup S1, Vector address Interrupt Status Register S1 Bit DIP switch settings for S1 Normal Speed Mode Speed Mode selectionHigh Speed Mode Software Installation Utility Installation Icom Utility Setup for Windows 95/98/NT EnvironmentsOperating Environment Selection Configuration Board Type PCL-849Vector Address 200H ~ 3F0H Wiring Connector Pin Assignments RS-232 signal wiring RTS CTS GND DSR DTR DCD PC I/O Address Reference PC I/O Address Usage Quick Reference Jumper Setting · IRQ Mode COM1 JP1