MCS-1 Controller

1.) IR Receiver

2.) Source Selectors (1 - 6)

3.) Source LED ( 1 - 6)

4.) Power Status LED

MCS-1

CD1

POWER

CD2MUTE

DM1

5.) Mute Button

DM2

VOL

6.) Volume Up

7.) Volume Down

AMFM

TAPE

VOL

1.) IR Sensor - This is an Infrared Sensor window. We suggest you aim the external remote control directly at this window to pass commands back to and through the unit.

2.) Source Selector Buttons (1 - 6) - These buttons will select the source you want to listen to. Individual key caps (supplied with the unit) will allow you to “customize” the source selections. These can be: CD, Receiver, Tape, DSS, TV or whatever combination you wish.

3.) Source Selection LEDs (1 -6) - These Light Emitting Diodes (LED) will light up next to the selected source to let you know the selection was made.

4.) Power Status LED - This LED indicates the power status of the system. Lighted, the system is on and ready. Off, the system is not engaged.

5.) Mute Button - This button will instantly stop the audio through the system. It is used for temporarily muting the system such as to take a phone call or listen to someone speaking in another room.

6.) Volume Up - This raises the local zone volume up at a rate of 2-4 db per 1/10 second. Hold down the control and the volume goes up quickly.

7.) Volume Down - This lowers the local zone volume down at a rate of 2-4 db per 1/10 second. Hold down the control and the volume goes down quickly.

Page 5