Channel Plus MDS-6 manual MCS-2 Controller

MCS-2 CONTROLLER

The left side of this controller is identical to the MCS-1 consult last page.

8.) Reset

9.) Clear

10.) Clone RX

11.) Clone TX

12.) Clone/Learn LED

13.) OK LED

14.) Learn Button

15.) IR Sensor LED

		MCS-2
		RESET
			1	2	3
		CLEAR
CD1			4	5	6
	POWER
		CLONE RX
CD2	MUTE		7	8	9
		CLONE TX
DM1			E	0	M
		CLONE/
	VOL	LEARN	OK
DM2					PWR
		ERROR
		LEARN
AMFM	VOL				PLAY

IR SENSOR

TAPE

16.) Numeric Entry

17.) Enter Button

18.) Macro Button

19.) Skip Backward

20.) Skip Forward

21.) Power On

22.) Reverse

23.) Forward

24.) Play

25.) Pause

26.) Stop

8.) Reset - This resets the local zone controller if an IR command “locks up” the zone. It will not erase the local zone memory. It will just send a local clear command.

9.) Clear - This button has 3 modes: a.) Device mode - will clear learned commands from the local zone memory. If you press clear and then say source selector #1 then the commands associated with that page of memory will be erased. b.) Storage mode - this will allow any individual key to be erased and reprogrammed. c.) Macro memory mode - this will allow you to reprogram a individual macro key (0 -9).

(This is a permanent erase function, so be careful with this command.)

10.) Clone RX - This button will place the controller into a “ready to receive commands” mode. This is the learning mode. When setting up the system initially, place all but one controller in this mode and use the one master controller to teach the local zones their commands. The clone/learn LED will light and stay on. When the data is received correctly, the red LED will go out and the green OK light will go on. This process takes between 6 and 8 minutes. *See detailed “clone” description on page 8.

11.) Clone TX - This button will place the controller into a “ready to transmit commands” mode. This is the teaching mode. When setting up the system initially, place one controller in this mode and use it as a master controller to teach the other local zones their commands. The clone/learn LED and OK LED will stay on. When the data is transmitted correctly, the red LED will go out and the green OK light will flash then go off. This process takes between 6 and 8 minutes. *See Page 8.

12.) Clone/Learn LED - This LED will let you know the status of transmit and receive during the learning or teaching processes.

13.) OK - This LED will also let you know the progress of the learning/teaching processes. *See Page 8.

14)Learn Button - This button puts the controller into a learning mode.*See Page 8.

15.) IR Sensor - Use this IR window when teaching a controller new IR commands with an external remote.

Page 6