Asus PTGD1-LA manual ATX power connectors 24-pin ATXPWR, 4-pin ATX12V, Atxpwr

3 . ATX power connectors (24-pin ATXPWR, 4-pin ATX12V)

These connectors are for an ATX power supply. The plugs from the power supply are designed to fit these connectors in only one orientation. Find the proper orientation and push down firmly until the connectors completely fit.

• Do not forget to connect the 4-pin ATX +12 V power plug; otherwise, the system will not boot up.

•Make sure that your ATX 12V power supply can provide 8A on the +12V lead and at least 1A on the +5-volt standby lead (+5VSB). The minimum recommended wattage is 230W, or 300W for a fully configured system. The system can become unstable and might experience difficulty powering up if the power supply is inadequate.

•You must install a PSU with a higher power rating if you intend to install additional devices.

					ATXPWR
		+3		Volts		Ground ATX12V
		+12		Volts		+5 Volts
			+12	Volts		+5 Volts
			+5V Standby			+5 Volts
			Power OK			-5 Volts	GND +12V DC
			Ground			Ground
		+5		Volts		Ground
			Ground			Ground
	PTGD-LA		+5 Volts			PSON#
			Ground			Ground	GND +12V DC
		+3		Volts		-12 Volts
PTGD1-LA ATX power connectors +3 Volts						+3 Volts

ASUS PTGD1-LA (Puffer M-UL8E) 1 5