3 Preparation
This section provides instructions about how to apply firmware updates (if necessary) and how to set up the device for manual configuration.
3.1PC Network Settings
The factory default on CyberData products is a static IP address. To access the device, you must change your PC to the same address range.
To change the IP Address for your computer, do the following:
NOTE: Make a note of your original network settings before making any changes because you need to change these settings back after changing the network configuration on the speaker.
For Windows Server 2003/XP
1.Click Windows Start.
2.Click Control Panel.
3.If you have the classic view, click Network Connections.
If you have the category view, click Network and Internet Connections, and then click Network Connections.
4.Double‐click the active LAN or Internet connection.
5.Click Properties.
6.In the General tab, highlight the Internet Protocol (TCP/IP) item, and click Properties.
7.In the General tab, click Use the following IP address, and enter: IP Address: 192.168.3.1
Subnet Mask: 255.255.255.0
Default Gateway: 192.168.3.10
8.Click OK.
For Windows Server 2008/Windows Vista
1.Click Windows Start.
2.Click Control Panel.
3.If you have the classic view, click Network and Sharing Center and then click Manage Network Connections.
If you have the category view, click Network and Internet, View network status and tasks and then click Manage Network Connections.
4.Double‐click the active LAN or Internet connection.
5.Click Properties.
6.In the Networking tab, highlight the Internet Protocol (TCP/IP) item, and click Properties.
7.In the General tab, click Use the following IP address, and enter: IP Address: 192.168.3.1
Subnet Mask: 255.255.255.0
Default Gateway: 192.168.3.10
8.Click OK.
7
Objectworld Communications Corp. • 308 Legget Drive • Ottawa, ON • Canada • K2K 1Y6 • T: 613‐599‐9698 • F: 613‐599‐7457 •www.objectworld.com