Crate Amplifiers VTX200 manual Top Panel

VTX200 Three-Channel Guitar Amplifier with Advanced DSP

The Top Panel:

LOW	MID	HIGH	LOW	MID	HIGH
GAIN		LEVEL	GAIN		LEVEL
		1			2

INPUT

1 2 3 4 5 6 7 8 9 10 11 12 13

1:INPUT: Use this jack to connect your guitar to the amplifier by means of a shielded instrument cable.

CHANNEL 1 - Featuring a low gain FlexWave circuit for clean sounds or sounds with mild dis- tortion:

2:LOW: Use this control to adjust the low frequency level of Channel 1.

3:GAIN: Use this control to adjust the amount of distortion produced by Channel 1.

4:MID: Use this control to adjust the midrange frequency level of Channel 1.

5:LEVEL: Use this control to adjust the output level of Channel 1.

6:HIGH: Use this control to adjust the high frequency level of Channel 1.

7:CHANNEL 1 SELECT: This switch, when depressed, selects Channel 1 as the active channel. The adjacent LED illuminates when Channel 1 is active.

CHANNEL 2 - Featuring a medium gain FlexWave circuit for moderate distortion and crunch:

8:LOW: Use this control to adjust the low frequency level of Channel 2.

9:GAIN: Use this control to adjust the amount of distortion produced by Channel 2.

10:MID: Use this control to adjust the midrange frequency level of Channel 2.

11:LEVEL: Use this control to adjust the output level of Channel 2.

12:HIGH: Use this control to adjust the high frequency level of Channel 2.

13:CHANNEL 2 SELECT: This switch, when depressed, selects Channel 2 as the active channel. The adjacent LED illuminates when Channel 2 is active.

CHANNEL 3 - Featuring a high gain FlexWave circuit for extreme distortion and sustain:

14:LOW: Use this control to adjust the low frequency level of Channel 3.

15:GAIN: Use this control to adjust the amount of distortion produced by Channel 3.

16:MID: Use this control to adjust the midrange frequency level of Channel 3.

17:LEVEL: Use this control to adjust the output level of Channel 3.

18:HIGH: Use this control to adjust the high frequency level of Channel 3.

19:CHANNEL 3 SELECT: This switch, when depressed, selects Channel 3 as the active channel. The adjacent LED illuminates when Channel 3 is active.

4