9. Front panel audio connector (10-1 pin AAFP)
This connector is for a
Legacy | |
pin definition | pin definition |
AGND PRESENSE# MIC2 JD | HP HD | AGND NC NC NC | |
| AAFP |
|
|
| MIC2 L MIC2 R HP R Jack Sense HP L | MIC2 L MIC2 R Line out R NC Line out L |
P5GC-MX Front Panel Audio Connector
•We recommend that you connect a
•By default, this connector is set to AC97 Audio. If you want to connect a High Definition front panel audio module to this connector, set the Front Panel Support Type item in the BIOS to [HD Audio].
See section “2.4.4 Onboard Device Configuration” for details.
10. Chassis intrusion connector (4-1 pin CHASSIS)
This connector is for a
is removed or replaced. The signal is then generated as a chassis intrusion event.
By default, the pins labeled “Chassis Signal” and “Ground” are shorted with a jumper cap. Remove the jumper caps only when you intend to use the chassis intrusion detection feature.
CHASSIS
GND (Default) Chassis Signal
+5VSB_MB
P5GC-MX Intrusion Connector
Chapter 1: Product introduction |