Enterasys Networks SNS-TAG-HPA, SNS-TAG-LPA manual Appliance Back Panel, Control Button Functions

Page 20

Appliance Back Panel

Table 1-1 Control Button Functions

Button	Function

Power	Toggles the system power on/off.

Reset	Performs a soft system re-boot.

UP/DOWN	Displays configured appliance parameters on the LCD.
	•	Appliance IP Address
	•	Gateway IP Address
	•	Appliance Network Mask
	• Management Server IP Address

ENT	Displays the installed TAG software version number on the LCD.

ESC	Displays “Enterasys Networks” on the LCD.

Appliance Back Panel

Figure 1‐2 shows the appliance back panel.

Figure 1-2 Back Panel

A. Video connector	D. Console connector
B. NIC1 connector (Eth 0) (10/100/1000 Mbit)	E. Power supply
C. NIC2 connector (Eth 1) (10/100/1000 Mbit)	F. Power connector

Note: The LEDs on the NIC connectors are not functional.

1-2 Appliance Overview

Image 20

Contents Enterasys Sentinel Page Page Regulatory Compliance Information Electromagnetic Compatibility EMC Supplement to Product Instructions Vcci Notice Enterasys NETWORKS, INC. Firmware License Agreement Vii Viii Enterasys NETWORKS, INC. Software License Agreement Page General Xii Contents Xiv About This Guide Intended AudienceAssociated Documents Conventions Used in This GuideGetting Help Support@enterasys.comAppliance Overview Kit ContentsFront Panel Controls and Indicators Appliance Back Panel Control Button FunctionsPower Supply Physical SpecificationsEnvironmental Specifications Environmental Specifications Parameter DescriptionInstallation Safety InformationSafety Information Safety Information Rack Mounting Rack Mounting-Front MountMid-Mount Rack Mounting Installation Configure the Appliance ConfigurationPre-Configuration Tasks Configure the Appliance Changing Trusted Access Gateway Settings Changing Basic Network ConfigurationChanging Trusted Access Gateway Settings Configuration Upgrading Trusted Access Gateway Software Upgrading Trusted Access Gateway Software