ADC ISDN NT11010 manual Setting up your hardware, Taking inventory, Front panel LEDs, Power LED

Page 13

C H A P T E R

2 Setting up your hardware

Taking inventory

The 1010 package contains the following items:

■One 1010 unit

■One RJ11 to RJ45 cable

■One RJ45 to RJ45 cable

■One power supply unit (AD62010)

■One plastic wall mount bracket

■Two jumpers

■Two screws and two plastic anchors for wall mounting

■User’s Guide

■One warranty card

Front panel LEDs

There are three (3) LEDs on the front panel of the 1010.

Figure 2—1010 NT1 front panel

U

LOOP

POWER S/T&U BACK

Power LED

When the 1010 is plugged into the wall outlet, the POWER LED will be on.

5

Image 13

Contents Isdn NT1 Page Iii Document printing historyImportant safety information Limitation of warranty Warranty informationDisclaimer of warranty and limitation of remedies Page Contents Page Who is this manual for? PrefaceWho to call for assistance Page Introduction 1010 NT1 physical dimensionsPage Power LED Setting up your hardwareTaking inventory Front panel LEDsLoopback LED U LEDT interface RJ45 connector pin assignments Pin Function Installing your unitRear panel DIP switch setting Power connectorPower connector pin assignments Pin Function Dip switch pin assignments Switch Function OffInternal jumper settings Wiring diagram Wiring instructionsWall mounting instructions Power sourcePage End of Passive Bus P-P T bus configurationExtended Passive Bus Cluster Multipoint Specifications SpecificationsFCC compliance information