ADC ISDN NT11010 manual Document printing history, Iii

Page 3

Copyright © 1998. ADC Kentrox. All Rights Reserved.

Specifications published here are current or planned as of the date of publication of this document. Because we are continuously improving and adding features to our products, ADC Kentrox reserves the right to change specifications without prior notice. You may verify product specifications by contacting our office.

The information in this document is subject to change without notice.

ADC Kentrox shall not be liable for technical or editorial errors or omissions which may occur in this document; nor for the incidental or consequential dam- ages resulting from the furnishing, performance, or use of this document. This document contains information protected by copyright. No part of this document may be reproduced in any form without the prior written consent of ADC Ken- trox.

Document printing history

Part #

Date

Description

65-10100101

December, 1998

Issue 1

iii

Image 3
Contents Isdn NT1 Page Iii Document printing historyImportant safety information Warranty information Limitation of warrantyDisclaimer of warranty and limitation of remedies Page Contents Page Preface Who is this manual for?Who to call for assistance Page Introduction 1010 NT1 physical dimensionsPage Front panel LEDs Setting up your hardwarePower LED Taking inventoryLoopback LED U LEDInstalling your unit T interface RJ45 connector pin assignments Pin FunctionRear panel Dip switch pin assignments Switch Function Off Power connectorDIP switch setting Power connector pin assignments Pin FunctionInternal jumper settings Wiring diagram Wiring instructionsWall mounting instructions Power sourcePage End of Passive Bus P-P T bus configurationExtended Passive Bus Cluster Multipoint Specifications SpecificationsFCC compliance information