Chapter 5: Operation and Control
Table
STATUS
UNDO
Inquiring status button: To inquire about the present status.
Example 1: To inquire the status of output channel 7.
Operation: Press buttons in the following order “7”, “STATUS”.
Example 2: To inquire the status of all the output channels one by one.
Operation: Press the “STATUS” button.
Undo button: To resume to the previous status of the command.
Group programming button: To define, recall and clear a group of output channels.
Example 1: To group the output channels 1, 2, 3, 4, 5 under the Group 1.
Operation: Enter this sequence: “1”, “Program”, “Program”, “1”, “2”, “3”, “4”,“5”.
| Example 2: To transfer signal from input channel 1 to Group 2. |
PROGRAM | Operation: Enter this sequence: “1”, “Program”, “2”. |
| Example 3: To clear the output channels under Group 1. |
| Operation: Enter this sequence: “1”, “Program”, “0”. |
| NOTE: Please clear the group to be set before grouping it. |
|
|
Backspace button: To erase the last input entry that was entered. | |
|
|
| Through button: To transfer signals directly to the corresponding output channels. |
THROUGH | Example: To transfer signals from input channels 1, 2, 3 to their corresponding output channels. |
| Operation: Enter this sequence: “1”, “/”, “2”, “/”, “3”, “THROUGH”. |
|
|
| Close button: To switch off the output channels. |
CLOSE | Example: To switch off the output channels 1, 2. |
| Operation: Enter this sequence: “1”, “END”, “2”, “END”, “CLOSE”. |
|
|
| Lock button: To lock buttons on the front control panel hold it for 3 seconds. |
LOCK | NOTE: When the control panel is locked, the Matrix Switch still can be controlled via the |
| |
| need a password to unlock it. |
|
|
| Demo button: To demonstrate the commands one by one every 3 seconds. |
DEMO | The Switch can be controlled directly by entering the following command: |
| “Input Channel” + “Switching Mode” + “Output Channel” + “END”+ “ENTER”. |
|
|
Page 16 |