Computer systems

Each computer system is connected to the Wizard DVI DL unit using up to three cables.

To connect a computer system

1Ensure that power is disconnected from the Wizard DVI DL unit and the system to be connected.

2Use a DVI cable or a VGA to DVI/I conversion cable (if using analogue signals) to link the video output of the computer’s graphic port to the DVI/I port of the required channel on the rear of the unit.

		DVI-I
	2	DVI-I
	From the USB port	1
	From the USB port
	on the computer
		OPTIONS
	From the speaker port	From the video port
	From the speaker port	on the computer
	on the computer	on the computer
	on the computer

3Use a USB cable (type-A to type-B) to link a USB port on the computer system to the USB port of the required channel on the rear of the unit.

4If required, use a stereo audio link cable (3.5mm jacks at either end) to link the speaker port on the computer system to the audio port of the required channel on the rear of the unit.

Power in connection

The Wizard DVI DL unit is supplied with a standard 20W power adapter. There is no on/off switch on the unit, so operation begins as soon as a power adapter is connected.

To connect the power supply

1Attach the output lead from the power adapter to the 5V socket on the rear panel

of the unit.

	VGA
5V
4A			U
	1		U
	1
USE	ON	2	US
		2
	ONLY

2Connect the IEC connector of the supplied country-specific power lead to the socket of the power adapter.

3 Connect the power lead to a nearby main supply socket.

Note: Both the unit and its power supply generate heat when in operation and will become warm to the touch. Do not enclose them or place them locations where air cannot circulate to cool the equipment. Do not operate the equipment in ambient temperatures exceeding 40 degrees Centigrade. Do not place the products in contact with equipment whose surface temperature exceeds 40 degrees Centigrade.

   

