ABOUT THIS GUIDE
Introduction
For information on | Turn to |
This guide provides all the information that you need to set up your CoreBuilder® 9400 system and get it operating in your network. This guide provides an overview of your system and
Best ways to use the CoreBuilder® 9400 system
The front and back panels
Site requirements and other issues to consider before you install your CoreBuilder 9400 system
Installing the system on a table or in a distribution rack
“System Features and Benefits” on page 11
“System Overview — Front Panel” starting on page 13
“General Safety Requirements” starting on page 47
“Installing the System on a Table Top” on page 17 and “Installing the System in a Distribution Rack” on page 18
If the information in the Software Installation and Release Notes that are shipped with your system differs from the information in this guide, follow the instructions in the Release Notes.
This guide is intended for the system or network administrator who is responsible for installing and managing network hardware. It assumes that you have a working knowledge of local area network (LAN) operations, but it does not assume prior knowledge of the CoreBuilder 9400 system.
Finding Specific Information in This Guide
This table shows where to find specific information.
Cabling the CoreBuilder 9400 | Chapter 3 |
system |
|
Checking system | “Power Up” on page 29 |
diagnostics and LEDs |
|
Deciding how to manage your | “How Do You Want to Manage |
system | the System?” on page 33 |
Setting the Console port baud | “Changing the Console Port |
| Baud Setting” on page 35 |
Configuring the IP management | “IP Management Interface” on |
interface | page 34 |
Troubleshooting hardware and | “Diagnosing Problems” on |
software problems | page 37 |
Removing and replacing the | “Removing and Replacing the |
power supply | Power Supply” on page 43 |