Mounting to a Single Gang Box

Lathem DDC2 manual Mounting to a Single Gang Box

Digital Display Wall Clock Guide	Page 12

»Slide the lens and circuit board assembly back into the case, replace the end cap and secure with the four phillips head screws.

DDC4

»After deciding the location where the clock will be mounted, make two marks 12" apart and horizontal.

Note: If mounting near a ceiling, make sure the holes are at least 2 1/4" away from the ceiling.

Note: Make sure you have at least 16" of side clearance on one side in order to remove the front panel.

»Drill a 5/16" hole at each mark

»Insert a wall anchor and tap it flush to the wall with the hammer.

»Insert a screw into each wall anchor leaving 1/4" exposed.

»Remove the two phillips head screws from the left or the right end cap and remove. Slide the front panel assembly out of the case and set aside.

»Line up the two keyholes on the back of the case and slip over the two screws and tighten securely. ( The lower mounting holes can be marked at this point, the case removed, holes drilled and wall anchors installed if so desired)

»Remove the desired vent cap that any required wiring will route through. (If the wiring will be installed through the back-of-the-clock conduit access, route the fly leads of the clock's Cable Harness Assembly from the interior of the clock through the hole in the Clock's rear plate. Use wire nuts or crimp connectors to join these leads with the power and synch signal cable in the gang box behind the clock to eliminate possible snagging when the circuit board assembly is removed or replaced. If RS-485 signaling is used, attach the signal pair to the mini Terminal Block Plug and pass the cable from behind the clock, through the hole into the clock's interior).

»Route the 6-position plug (and optional RS485 cable) to the circuit board assembly and attach.

»Slide the front panel display back into the case, replace the end cap and secure with the two phillips head screws.

Two mounting holes have been located in the center of the case 2 1/4" apart for mounting to a single gang wall box. A 7/8" hole has been placed between the mounting holes that will accept conduit if desired.

See page 14, figure 3.