2000 – 4000 Series Time Recorder User’s Guide
Install / Replace Batteries in BATT
Figure 9
The 2000-BATT requires four “D” size batteries and should operate for six months before replacement. An internal beeper sounds momentarily each minute when the battery supply discharges below 4.5 volts. Replace batteries as follows when this occurs:
1.Pull and remove the front two rubber feet underneath the unit.
2.Loosen, 1 to 2 turns, the two phillips-head screws located 1.5 inches directly inside the rubber feet mounting holes.
3.Slide the bottom battery compartment outward (to front) and down, to get to the batteries. (See Figure 9.)
4.Replace the four “D” size batteries. Be sure the batteries are installed with proper polarity (+/-) as marked on battery holder.
5.Re-install the battery compartment on the bottom of the recorder, aligning the holes with the screws. Press the compartment firmly to the back (inward), tighten the two Phillips-head screws, and re-insert the two rubber feet.
Page 11
