Lathem 4000 manual Changing the Motor, Shows a close-up of cam block terminal

Page 14

2000 – 4000 Series Time Recorder User’s Guide

Changing the Motor

Figure 10

1.Unplug cord from wall outlet (except 2100BATT).

2.Remove type section from main frame (see “Replacing the Type Section”).

3.Figure 10 shows a close-up of cam block terminal.

4.Disconnect Motor Wire Leads – Figure 10, 10.1 by turning each Screw – 10.2 one-quarter of a turn counterclockwise.

5.Remove the Motor Clutch – Figure 10, 10.3 from its shaft. The shaft has LEFT HAND threads – remove clutch by turning clockwise.

6.Hold Motor Bracket – Figure 10, 10.4 and loosen Motor Mounting Screws – Figure 10, 10.5. Remove and retain screws and bracket from old motor.

7.Install motor clutch on new motor. Turn counterclockwise to tighten. DO NOT OVERTIGHTEN OR BEND – YOU MAY DAMAGE INTERNAL MOTOR GEARS.

8.Install new motor.

9.Install the new motor wire leads into the cam block terminal – Figure 10, 10.1 by turning each Screw – 10.2 one-quarter of a turn clockwise.

10.Plug cord back in wall outlet, and reset the time.

Page 12

Page 13 Page 15
Image 14
Page 13 Page 15
Contents 2000 4000 Series Contents Ordering Accessories Setting the Time Determine Your ModelRaise the Type Section Set the Time on the Type WheelsPage Dial of Decimal Equivalents Setting Decimal Wheel with Tenths Set the Time on the Analog Clock Face Make a sample registration on paperSet the Time on the Digital Clock Face Changing the Ribbon Replacing the Type Section Install / Replace Batteries in Batt Changing the Motor Shows a close-up of cam block terminalWarranty OMOV0605A Revised
Top Page Image Contents