B.If liquid has been spilled into the product.
C.If the device has been exposed to rain or water.
D.If the device does not operate normally when the operating instructions are fol- lowed. Adjust only those controls that are covered by the operating instructions since improper adjustment of other controls may result in damage and will often required extensive work by a qualified techinician to restore the product to nor- mal operation.
E.If the device has been dropped or the cabinet has been damaged.
F.If the device exhibits a distinct change in performance, indicating a need for service.
14.Make sure that the wall outlet is near the scanner and easily accessible.
15.The main plug on this equipment must be used to disconnect main power.
16.Use the standard cable attached to this scanner. Otherwise, use cables that meet the following requirements.
Area | Rating | Plug | Cable | Connector |
North America | 120V | NEMA | SVT or SJT 18/3 | IEC320 type |
| 15A |
| AWG Less than |
|
|
|
| 1.6 m long |
|
|
|
|
|
|
Europe | 230V | Use the required | EN60320 type | |
| equivalen t for |
| ||
| 10A | each country |
|
|
|
|
|
|
|
- iv -