Refer to Attachment 5. Bluetooth master Setting

5)Bluetooth master setting

-Connect Bluetooth main (master/slave) to USB (or Serial) port of PC.

-Execute BluetoothConfig_V2.x.exe from the downloaded files.

-Select the port

a)USB port: Select the virtual port (COM x) of step 2).

b)Serial (RS-232C): Select the COM x connected.

-Configure Adapter setting: master, 19200, hardware

-Register Printer setting: Search the printers around and save the printer address by button “Search”. Make sure the printers are all power on mode.

-Configure Adapter setting: Check in auto connector to printers.

-Click “ok”.

-Refer to Attachment 5. Bluetooth master Setting

6)Printer driver installation & Test page printing

-Once the setting’s complete, disconnect the Bluetooth master from the PC, reconnect it and initialize the system. Turn the printer off and then on to initialize the Bluetooth slave.

-Wait for approximately 20 seconds for the Bluetooth master and slave are automatically reconnected.

-Install the printer driver (Available at website)

a)SRP 350: V3.0.5E above

b)SRP 270: V3.0.3E above

-You can download the printer driver from the homepage. Make sure that you delete the older version driver from the PC before you install the new one(Clean register)

-Open the printer driver and select a port

a)USB port: Select the virtual port (COM x) of step 2).

b)Serial (RS-232C): Select the COM x connected.

-Set the port settings as below (19200, 8, none, 1, hardware)

-Test Page Printing.

-Refer to Attachment 6. Test page printing

7)Other

-If you are a POS Application Programmer, refer to the manual below for more information.

:“Bluetooth control message V1.x

V1.00