Front Panel LED Indicators
The three lights on the front panel indicate the status of your TV.
: Light is On | : Light is Blinking | : Light is Off |
|
| |
TIMER LAMP STAND BY/TEMP | Indication | |
Standby state.
The picture will automatically appear in about 15 seconds.
Auto Timer ON/OFF has been set and the set will automatically be turned on in about 25 seconds.
A cooling fan inside the set is not operating normally.
Lamp cover on rear of the set is not properly shut.
Check if the ventilation hole on the rear of the set is blocked, because if the inner temperature is too high, the power will shut off.
Lamp may be defective. Please contact a certified technician.
•It takes about 30 seconds for the TV to warm up, so normal brightness may not appear imme- diately.
•The TV has a fan to keep the inside lamp from overheating. You’ll occasionally hear it working.
Troubleshooting
If the TV seems to have a problem, first try this list of possible problems and solutions. If none of these troubleshooting tips apply, then call your nearest Samsung authorized service center.
Poor picture quality. | Poor sound quality. | No picture or sound. |
Try another channel. | Try another channel. |
Adjust the antenna. | Adjust the antenna. |
Check all wire connections. | Make sure the MUTE button is off. |
Try another channel. Press the SOURCE button. Make sure the TV is plugged in. Check the antenna connections.
No color, wrong colors or tints. Picture rolls vertically. | ||
Make sure the program is broadcast- | Adjust the antenna. | |
ed in color. | Check all wire connections. | |
Adjust the picture settings. | If you are using a VCR, check the track- | |
ing. | ||
| ||
The TV operates erratically.
Unplug the TV for 30 seconds, then try operating it again.
Your remote control does not | The TV won’t switch on. | Digital broadcasting screen |
operate your TV. |
| problem. |
Press the Mode button to put your remote control into TV mode.
Make sure the remote has batteries.
Make sure the wall outlet is working. | Please check the digital signal |
Make sure the TV is plugged in. | strength and input antenna. |
Make sure the remote has batteries. |
|
•The display panel used for the DLP TV is composed of many tiny pixels. These pixels may occasionally appear on the screen.
15
Downloaded from www.Manualslib.com manuals search engine