| 페이지 3 / 3 |
Severe vibration or external impact may decrease the quality of printed images. Firmly install the product into the PC before use.
In case of a disc identification error message, thoroughly clean the surface of the disc where the label is presented and then start printing.
The quality of the printed image cannot be ensured if printing an image on the area which is already used for printing.
For more information on the writing, install CyberLink software and refer to the HELP section.
Specifications are subject to change without notice.
Top
FCC information to the user
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Caution
Change or modifications not expressly approved by the manufacturer responsible for compliance could void the user's authority to operate the equipment.
Top
Laser Standard
EN
Important
The product specifications above may be changed to improve device performance without prior notice.
Top
file://D:\HEARTSOME_WORK\0_PROJECT_LOCALIZATION\3_TOSHIBA_SAMS... 4/2/2010