Samsung S24C770T user manual Enabling PC or AV mode, Adjusting the volume

Page 38

Enabling PC or AV mode

-- After changing the PC/AV mode, the monitor may need to be calibrated again. -- To calibrate the monitor again, refer to "Calibration" on page 25.

Adjusting the volume

100

Enable PC or AV mode according to the source device connected to the product.

――Press one of the four buttons, other than the power button, found at the bottom right front of the product. The key guide will appear.

1

Tap the

button from the key guide.

2

Go to

using the

buttons, and tap

.

3

Go to the desired option using the

buttons, and tap

.

: Enable PC mode. This mode is suitable for a PC.

: Enable AV mode to enlarge the image size displayed on the product. This mode is suitable when viewing movies.

4 Changes are applied and the OSD menu is closed.

Adjust the volume as follows.

――Press one of the four buttons, other than the power button, found at the bottom right front of the product. The key guide will appear.

1	Tap the				button from the key guide.
1	Tap the				button from the key guide.
2
	Tap			.
	Tap			.
3	Adjust the volume using the									buttons, and tap		.


4	Changes are applied and the OSD menu is closed.

38

Image 38

Contents S24C770 Table of contents Specifications Before Using the Product CopyrightPrecautions for storage Securing the Installation SpaceSafety Precautions SymbolsCleaning Electricity and SafetyInstallation Samsung Operation Output ports, etc Page Correct posture to use the product Tilting the productChecking the Contents PreparationsChecking the Components ComponentsIcons PartsFront Buttons DescriptionReverse Side Port DescriptionAdjusting the Product Tilt 53 ~Anti-theft Lock To lock an anti-theft locking deviceRequirements Using MagicTune TouchAbout MagicTune Touch Uninstallation Installing/Uninstalling MagicTune Touch WindowsInstalling MagicTune Touch Mac Select MagicTune TouchRead below before using the product Touchscreen monitorConnecting to a laptop or tablet PC Connecting the touchscreen monitorConnecting to a PC Configuring the touchscreen monitor settings Accessing the calibration menuAccessing the calibration menu from MagicTune Touch Run MagicTune TouchCalibration Touch this screen to identity it as the touchscreenDigitizer Calibration Tool Select Touch Base Configuring the touchscreen monitor settings from a MacInstalling Touch Base Controlling the screen Basic touch functionsFlick Pre-connection Checkpoints Connecting and Using a Source DeviceBefore Connecting Connection Using an Hdmi Cable Connection Using an HDMI-DVI Cable Connecting to an Audio System Connecting the Power Changing the Resolution Changing the Resolution on WindowsExiting from the menu Adjusting the brightness OSD menuPC mode AV mode Changing the screen sizeConfiguring the Hdmi black level Enabling PC or AV mode Adjusting the volumeChecking the Resolution and Frequency Troubleshooting GuideTesting the Product Check the followings Installation issue PC modeScreen issue Sound issue Source device issueTouch point does not match Touch function issuesTouch function does not work Question Answer Model Name SpecificationsGeneral Power Supply Resolution Optimum resolutionMaximum resolution Signal connectorsPower Consumption PowerSaverPower Indicator Pixel Clock MHz Sync Polarity H/V KHz Preset Timing ModesResolution Horizontal Frequency Appendix Contact Samsung World WideCosta Rica Dominica Ecuador Europe Italia Asia Pacific India Africa Ghana Not a product defect Responsibility for the Pay ServiceCost to CustomersProduct damage caused by customers fault OthersCorrect Disposal Correct disposal of batteries in this productLicense Terminology 480i / 480p / 720p