Samsung 93V Symptom, No images on the screen. I cannot turn on the monitor, Check List, Solutions

Page 34

Before calling for service, check the information in this section to see if you can remedy any problems yourself. If you do need assistance, please call, the phone number on the Information section or contact your dealer.

Symptom

No images on the screen. I cannot turn on the monitor.

Check List

Is the power cord connected properly?

Can you see "Check Signal Cable" on the screen?

If the power is on, reboot the computer to see the initial screen(the login screen), which can be seen.

Can you see "Not Optimum Mode" "Recommanded mode 1280 x 1024 60Hz" on the screen?

Solutions

Check the power cord connection and supply.

Check the signal cable connection.

If the initial screen (the login screen) appears, boot the computer in the applicable mode (the safe mode for Windows ME/XP/2000) and then change the frequency of the video card. (Refer to the Preset Display Modes)

Note: If the initial screen (the login screen) does not appear, contact a service center or your dealer.

You can see this message when the signal from the video card exceeds the maximum resolution and frequency that the monitor can properly handle.

Adjust the maximum resolution and frequency that the monitor can properly handle.

If the display exceeds SXGA or 75Hz, a "Not Optimum Mode. Recommended mode 1280 x 1024 60Hz" message is displayed. If the display exceeds 85Hz, the display will work properly but the "Not Optimum Mode. Recommended mode 1280 x 1024 60Hz" message appears for one minute and then disappears.

Please change to the recommended mode during this one-minute period. (The message is displayed again if the

Page 33 Page 35
Image 34
Page 33 Page 35
Contents Samtron 73V/93V Select Model Name Do not use a damaged or loose plug Do not drop the monitor when moving itUse only a properly grounded plug and receptacle Do not place the monitor face down Place the monitor on a flat and stable surfaceSet down the monitor carefully Do not spray water or detergent directly on the monitorOther Do not use or store inflammable substances near the monitor Do not cover the vents on the monitor cabinetNever insert anything metallic into the monitor openings Page Unpacking Front Rear Power indicatorSub 15-pin port Unpacking Click here to see an animation clip Use this button for auto adjustment direct access Page Monitor Assembly Attaching a baseWindows XP/2000 Click Windows XP/2000 DriverMicrosoft Windows XP Operating System Page How to install Click Start , Setting , Control Panel Microsoft Windows NT Operating SystemLinux Operating System Select Model Name Attaching a base Click OK button Monitor driver installation is completed Page Page How to install Click Start , Setting , Control Panel Auto Description MenuMenu Description Menu Description Brightness Adjust Brightness PictureContrast Menu Description Play/StopBrightness Color Tone Color Control Gamma OSD Coarse Fine Sharpness PositionSetup Language Position Positon Transparency Display TimeInformation Solutions SymptomCan you see Check Signal Cable on the screen? No images on the screen. I cannot turn on the monitorPanel → Display → Settings Self-Test Feature Check Useful Tips General PowerSaver Horizontal Frequency Preset Timing ModesPreset Timing Modes Vertical FrequencyHorizontal 31 ~ 81 kHz Vertical 56 ~ 75 Hz Less than 38W Preset Timing Modes Service Samtron EuropeTerms For Better DisplayAuthority
Top Page Image Contents