Samsung 93V, 73V manual Self-Test Feature Check

Page 36

Q & A

Question

How can I change the frequency?

How can I adjust the resolution?

How can I set the Power Saving function?

How can I clean the outer case/LCD Panel?

Answer

Frequency can be changed by reconfiguring the video card.

Note that video card support can vary, depending on the version of the driver used. (Refer to the computer or the video card manual for details.)

Windows ME/XP/2000 : Set the resolution at the Control Panel→Display→Settings.

* Contact the video card manufacturer for details.

Windows ME/XP/2000 : Set the function at BIOS-SETUP of the computer or the screen saver. (Refer to Windows/Computer Manual).

Disconnect the power cord and then clean the monitor with a soft cloth, using either a cleaning solution or plain water.

Do not leave any remains of the detergent nor scratch the case. Do not allow any water to go inside the monitor.

Self-Test Feature Check

Self-Test Feature Check Warning Messages Environment Useful Tips

Your monitor provides a self test feature that allows you to check whether your monitor is functioning properly.

Self-Test Feature Check

1.Turn off both your computer and the monitor.

2.Unplug the video cable from the back of the computer.

3.Turn on the monitor.

If the monitor is functioning properly, you will see a box with a border and text inside as shown in the following illustration: The three boxes inside the border are red, green and blue.

Failure of any of the boxes to appear indicates a problem with your monitor. This box also appears during normal operation if the video cable becomes disconnected or damaged.

4.Turn off your monitor and reconnect the video cable; then turn on both your computer and the monitor. If your monitor screen remains blank after using the previous procedure, check your video controller and computer system; your monitor is functioning properly.

Page 35 Page 37
Image 36
Page 35 Page 37
Contents Samtron 73V/93V Select Model Name Do not drop the monitor when moving it Do not use a damaged or loose plugUse only a properly grounded plug and receptacle Place the monitor on a flat and stable surface Set down the monitor carefullyDo not place the monitor face down Do not spray water or detergent directly on the monitorOther Do not cover the vents on the monitor cabinet Do not use or store inflammable substances near the monitorNever insert anything metallic into the monitor openings Page Unpacking Front Power indicator RearSub 15-pin port Unpacking Click here to see an animation clip Use this button for auto adjustment direct access Page Monitor Assembly Attaching a baseWindows XP/2000 Click Windows XP/2000 DriverMicrosoft Windows XP Operating System Page How to install Click Start , Setting , Control Panel Microsoft Windows NT Operating SystemLinux Operating System Select Model Name Attaching a base Click OK button Monitor driver installation is completed Page Page How to install Click Start , Setting , Control Panel Auto Menu DescriptionMenu Description Menu Description Brightness Adjust Brightness PictureMenu Description Play/Stop BrightnessContrast Color Tone Color Control GammaOSD Coarse Fine Sharpness PositionSetup Language Position Positon Transparency Display TimeInformation Symptom Can you see Check Signal Cable on the screen?Solutions No images on the screen. I cannot turn on the monitorPanel → Display → Settings Self-Test Feature Check Useful Tips General PowerSaver Preset Timing Modes Preset Timing ModesHorizontal Frequency Vertical FrequencyHorizontal 31 ~ 81 kHz Vertical 56 ~ 75 Hz Less than 38W Preset Timing Modes Service Samtron EuropeTerms For Better DisplayAuthority
Top Page Image Contents