monitor, Plug & | manual to see if the |
Play (VESA DDC) | Plug & Play (VESA |
monitor found". | DDC) function can |
| be supported. |
Problems related to | No sound |
Audio |
|
Sound level is too low.
Installation Instructions.
Ensure that the audio cable is firmly connected to both the
(Refer to Connecting the Monitor)
Check the volume level.
Check the volume level.
If the volume is still too low after turning the control to its maximum, check the volume control on the computer sound card or software program.
Check when | MagicTune™ | * To check whether your PC is available for |
MagicTune™ does | feature is found only | MagicTune™ feature, follow the steps below (When |
not function | on PC (VGA) with | Windows™ is XP); |
properly. | Window OS that |
|
| supports Plug and | Control Panel → Performance and Maintenance → |
| Play. | System → Hardware → Device Manager → Monitors → |
|
| After deleting Plug and Play monitor, find 'Plug and Play |
|
| monitor' by searching new Hardware. |
|
| MagicTune™ is an additional software for the monitor. |
|
| Some graphic cards may not support your monitor. |
|
| When you have a problem with the graphic card, visit |
|
| our website to check the compatible graphic card list |
|
| provided. |
|
| http://www.samsung.com/monitor/magictune |
MagicTune™ | Have you changed | Download the latest program. The program can be |
doesn't work | your PC or video | downloaded |
properly. | graphic card? | http://www.samsung.com/monitor/magictune |
| Did you install the | Reboot the computer after installing the program for the |
| program? | first time. If a copy of the program is already installed, |
|
| remove it, reboot the computer, and then install the |
|
| program again. You need to reboot the computer for it to |
|
| operate normally after installing or removing the |
|
| program. |
Visit the MagicTune™ website and download the installation software for MagicTune™ MAC.
Check the following items if there is trouble with the monitor.
Symptom | Solutions |
The screen does not appear when I switch to the Client Mode.
When booting up, it takes about 30 seconds for the networking functions to be activated and no screen is displayed for about 3 to 4 seconds.
Wait 30 seconds after the power is turned on, and try to switch modes again.
If the operating system does not boot up due to damage to Windows or a blue screen is displayed, download the Windows XPe OS from this site and recover your operating system with it : http://www.syncsight.com
The client screen | 1) | Check if the Hub port LED to which the LAN cable is connected blinks. If not, |
appears, but I | that indicates that the LAN connection is disconnected. In this case, connect | |
cannot connect to | using another LAN cable. | |
the server. | 2) | Check if the settings of the 'Settings', 'Network' tab are properly set up. The |
| ||
| default setting is "DHCP". If your network uses a static IP address, select 'Use | |
| the following IP address' and then enter the appropriate IP address information. | |
| 3) | Check if the 'User Name' and 'Password' set in the 'Remote Desktop' tab of |
| 'Settings' are the same as those of the host PC. If not, match the 'User Name' | |