Plug and Play, Installing the Video Driver | Samsung 700NF specification

Setting up Your Monitor

Plug and Play

Our adoption of the new VESA¤ Plug and Play solution eliminates complicated and time consuming setup. It allows you to install your monitor in a Plug and Play compatible system without the usual hassles and confusion. Your PC system can easily identify and conﬁgure itself for use with your display. This monitor automatically tells the PC system its Extended Display Identiﬁcation (EDID) data using Display Data Channel (DDC) protocols so the PC system can automatically conﬁgure itself to use the ﬂat panel display. If your PC system needs a video driver, following the instructions given below according to the operating system your computer uses.

Installing the Video Driver

When prompted by the operating system for the monitor driver, insert the Driver diskette/ CD-ROM included with this monitor. Driver installation is slightly different from one operating system to another. Follow the directions as appropriate for the operating system you have.

Windows¤ 2000 and Windows¤ 98

1	Windows¤ 2000 and Windows¤ 98 will auto-detect your new monitor and start the
1	“Add New Hardware Wizard” if the drivers are not already installed. Click the NEXT
	button to search for drivers.
2	Check the diskette/CD-ROM drive box to install the drivers off the diskette/CD-ROM
2	provided with your monitor and click NEXT.
3	Conﬁrm that Windows found the driver on the diskette/CD-ROM and click NEXT
3	again to install the driver.

To manually install or update the driver, follow the directions below:

1	Click on START, SETTINGS, CONTROL PANEL, DISPLAY SETTINGS tab,
1	ADVANCED, MONITOR tab, CHANGE. This will start the “Add New Hardware
	Wizard”.
2	Follow the same directions as given in the steps in the section above.

English 5