Samsung 215TW manual Connecting AV Devices, Connecting DVD/DTV Set Top Box

Page 16

or a camcorder without disconnecting the PC.

The configuration at the back of the monitor may vary from product to product.

1. Connecting AV Devices

The monitor has AV connection terminals to connect AV input devices like DVD, VCR or Camcorder. You may enjoy AV signals as long as the monitor is turned on.

1.Input devices such as DVD, VCR or Camcorder are connected to the RCA or S-VIDEO terminal of the monitor using the RCA or S-Video cable.

2.Connect the port of the DVD, VCR (DVD / DTV Set-Top Box) to the R-AUDIO-Lport of the monitor

3.Then, start the DVD, VCR or Camcorder with a DVD disc or tape inserted.

4.Select AV or S-Video using the SOURCE.

5.In some areas, the image might slant to the side depending on the input broadcast signal.

2.Connecting DVD/DTV Set Top Box

Connect to the DVD/DTVSet Top Box input if the device has a DVD/DTV connector. You can watch Component simply by hooking up the Component with the monitor as long as the power is on.

Image 16
Contents SyncMaster 215TW Do not use a damaged or loose plug Insert the power plug firmly so that it does not come loose Do not place the product on the floor Do not spray water or detergent directly on the monitor Do not remove cover or back Do not cover the vents on the monitor cabinet Falling product could cause physical damage even death MagicRotation software CableMenu button Available in Analog mode only Available in Analog/DigitalPC Mode OnlyCustom TextPower button / Power indicator Speaker RGB Audio LPR, PB,Y Kensington LockPage Connecting the Monitor Connecting AV Devices Connecting DVD/DTV Set Top BoxConnecting Headphone Pivot StandTilt angle Removing the base Attaching a BaseWindows ME Click Windows ME DriverWindows XP/2000 Click Windows XP/2000 DriverInstalling the Monitor Driver Manual Microsoft Windows XP Operating SystemPage How to install Click Start , Setting , Control Panel Linux Operating System Microsoft Windows NT Operating SystemNatural Color Software Program How to install the Natural Color software AV/S-Video/Component Mode Analog/DigitalPC MagicBrightAuto Available in Analog mode only Play/Stop MagicBright Mode SourcePIP Available in Analog/DigitalPC Mode Only Source List Edit Name Analog Digital Video ComponentContrast MagicBright CustomBrightness Available in PC Mode Only Red Green Blue Available in Analog Mode Only CoarseFine SharpnessMode Custom Picture AV/S-Video/ComponentColor Tone Size Film Mode Cool2 / Cool1 / Normal / Warm1 / Warm2AV / S-Video Wide / Zoom1 / Zoom2 Component Wide Sound Select Main Sub Available PIP onOff Source Size PositionIf you select , in Size, Position will not be activated High Medium Low Opaque Blue Screen Reset Operates only for AV, S-Video and Component modeImage Reset Available in Analog Mode Only Color ResetOverview Installation Page Installation Problems It is recommended using MagicTune in Windows 2000 or later OSD Mode Color Tab Definition Image Tab Definition Support Tab Definition Color Calibration Press View Uncalibrated button to see the original image Uninstall Troubleshooting Symptom Check List Graphic card, visit our website to check Overview Page Page Installation Problems Interface Page Page Uninstall Page When connecting D-sub cable Signal Cable on the screen?When connecting DVI cable Display Settings Question Useful Tips Then contact the Service Center or your dealer General EPA/ENERGY Preset Timing Modes Horizontal FrequencyNorth America CIS Resolution Dot PitchVertical Frequency Horizontal FrequencyClass B MéxicoPage Warranty What is Image retention ?Power Off, Screen Saver, or Power Save Mode Suggestions for specific applications