Samsung 215TW manual Power button / Power indicator Speaker

Page 12

Power button [] / Power indicator

Speaker

the PIP screen in Analog and Digital (PC) mode.

Use this button for turn the monitor on and off.

This will enable you to see the overall power status of the system. For more information, see the PowerSaver section.

Headphone sound output terminal

You can hear sound by connecting the soundcard of your PC to the monitor.

See PowerSaver described in the manual for further information regarding power saving functions. For energy conservation, turn your monitor OFF when it is not needed, or when leaving it unattended for long periods.

Rear

(The configuration at the back of the monitor may vary from product to product.)

1. POWER

1.POWER S/W

:Switch the monitor on and off.

2.POWER

:Connect the power cord for your monitor to the POWER on the back of the monitor.

Image 12
Contents SyncMaster 215TW Do not use a damaged or loose plug Insert the power plug firmly so that it does not come loose Do not place the product on the floor Do not spray water or detergent directly on the monitor Do not remove cover or back Do not cover the vents on the monitor cabinet Falling product could cause physical damage even death MagicRotation software CableMenu button Available in Analog mode only Available in Analog/DigitalPC Mode OnlyCustom TextPower button / Power indicator Speaker RGB Audio LPR, PB,Y Kensington LockPage Connecting the Monitor Connecting AV Devices Connecting DVD/DTV Set Top BoxConnecting Headphone Pivot StandTilt angle Removing the base Attaching a BaseWindows ME Click Windows ME DriverWindows XP/2000 Click Windows XP/2000 DriverInstalling the Monitor Driver Manual Microsoft Windows XP Operating SystemPage How to install Click Start , Setting , Control Panel Microsoft Windows NT Operating System Linux Operating SystemNatural Color Software Program How to install the Natural Color software AV/S-Video/Component Mode Analog/DigitalPC MagicBrightAuto Available in Analog mode only Play/Stop MagicBright Mode SourcePIP Available in Analog/DigitalPC Mode Only Source List Edit Name Analog Digital Video ComponentMagicBright Custom ContrastBrightness Available in PC Mode Only Red Green Blue Available in Analog Mode Only CoarseFine SharpnessMode Custom Picture AV/S-Video/ComponentColor Tone Size Film Mode Cool2 / Cool1 / Normal / Warm1 / Warm2AV / S-Video Wide / Zoom1 / Zoom2 Component Wide Sound Select Main Sub Available PIP onSource Size Position OffIf you select , in Size, Position will not be activated High Medium Low Opaque Blue Screen Reset Operates only for AV, S-Video and Component modeImage Reset Available in Analog Mode Only Color ResetOverview Installation Page Installation Problems It is recommended using MagicTune in Windows 2000 or later OSD Mode Color Tab Definition Image Tab Definition Support Tab Definition Color Calibration Press View Uncalibrated button to see the original image Uninstall Troubleshooting Symptom Check List Graphic card, visit our website to check Overview Page Page Installation Problems Interface Page Page Uninstall Page Signal Cable on the screen? When connecting D-sub cableWhen connecting DVI cable Display Settings Question Useful Tips Then contact the Service Center or your dealer General EPA/ENERGY Preset Timing Modes Horizontal FrequencyNorth America CIS Resolution Dot PitchVertical Frequency Horizontal FrequencyClass B MéxicoPage Warranty What is Image retention ?Power Off, Screen Saver, or Power Save Mode Suggestions for specific applications