Samsung 180T manual Self-Test Feature Check STFC, Turn off both your computer and the monitor

Page 10

Self-Test Feature Check (STFC)

Setting up your LCD Monitor

Self-Test Feature Check (STFC)

Your monitor provides a self test feature that allows you to check whether your monitor is functioning properly. If your monitor and computer are properly connected but the monitor screen remains dark and the power indicator is blinking, run the monitor self-test by performing the following steps:

1

2

3

Turn off both your computer and the monitor.

Unplug the video cable from the back of the computer.

Turn on the monitor.

If the monitor is functioning properly, you will see a white box with a red border and black text inside as shown in the following illustration:

No Connection

Check Signal Cable

Figure 5. Monitor self test screen

The three boxes inside the border are red, green and blue. Failure of any of the boxes to appear indicates a problem with your monitor. This box also appears during normal operation if the video cable becomes disconnected or damaged.

4	Turn off your monitor and reconnect the video cable; then turn on both your computer
	and the monitor.

If your monitor screen remains blank after using the previous procedure, check your video controller and computer system; your monitor is functioning properly.

English 8

Image 10

Contents Dual InterfaceAnalog/Digital SyncMaster 180TTFT-LCD Monitor Owner’s InstructionsPage Auto Adjustment Table of ContentsPortuguese Italiano Español Deutsch Français English BrightnessDO NOT OPEN Warranty Card Unpacking Your LCD MonitorItaliano Portuguese Deutsch Español Français English DC-AdapterKensington Security Slot Setting up your LCD MonitorSetting up an Ergonomic Workstation Monitor locationItaliano Portuguese Deutsch Español Français Connecting Your LCD MonitorEnglish Figure 3. Cable connections AnalogSetting up your LCD Monitor Getting Help Auto AdjustmentPush the AUTO button to open the Auto Adjustment OSD Plug and PlayUnplug the video cable from the back of the computer Self-Test Feature Check STFCTurn off both your computer and the monitor Turn on the monitorItaliano Adjusting Your LCD MonitorPortuguese Deutsch Español Français English User ControlsBrightness Direct-Access FeaturesAutomatic Save Push the “+” button to increase theItaliano Portuguese Deutsch Español Auto AdjustmentFrançais OSD Lock/UnlockFigure 7. On Screen Display OSD Accessing the Menu SystemOn Screen Display OSD Setting slidebarunstable and jitters or shimmers Table 1. Menu Adjustmentsclosely adjust your monitor to your preference Fine againand changes the Image Size to Expand Table 1. Menu Adjustments Continuedfactory settings or Svenskasee more detail software you are usingthe addressability up to 1280 x recognizePowerSaver AppendixTroubleshooting sized properly Table 3. Troubleshooting problems ContinuedWhite does not look white onceSpeciﬁcations Referring to Preset timing modes, see pageTable 4. Speciﬁcations GND DDC Return Pin AssignmentsGreen H-SyncDisplay Modes Removing the Stand Turn off your monitor and unplug its power cordChanging the Stand screenMaintenance of Your LCD Monitor Attaching an Arm-Type Stand or Wall Mount HangerIndex IC Compliance Notice Regulatory InformationFCC Information MPR II ComplianceU.S.A