Installing Windows NT
2.If you have only IDE drives, press S. A list box of adapters will be displayed. Other should be highlighted. Press ENTER. You will be prompted to "Please insert the disk labeled manufacturer supplied hardware support disk into drive A:. *Press enter when ready *." Make sure that the Windows NT 4.0 Install Floppy for the AlphaPC 164UX diskette is in drive A: and press ENTER. A list box will be displayed. It will contain 2 entries, AlphaPC 164UX PCI Ultra SCSI (Symbios Logic 53C875), and AlphaPC 164UX PCI IDE (ATAPI). Highlight AlphaPC 164UX PCI IDE (ATAPI). And press ENTER. The next screen displayed will say "Setup will load support for the following device(s). AlphaPC 164UX PCI IDE (ATAPI)". Press the ENTER key to continue with setup.
3.If you have a combination of IDE and SCSI drives, press S. A list box of adapters will be displayed. Other should be highlighted. Press ENTER. You will be prompted to "Please insert the disk labeled manufacturer supplied hardware sup- port disk into drive A:. *Press enter when ready *." Make sure that the Windows NT 4.0 Install Floppy for the AlphaPC 164UX diskette is in drive A: and press ENTER. A list box will be displayed. It will contain 2 entries, AlphaPC 164UX PCI Ultra SCSI (Symbios Logic 53C875), and AlphaPC 164UX PCI IDE (ATAPI). Highlight AlphaPC 164UX PCI Ultra SCSI and press ENTER. The next screen displayed will say "Setup will load support for the following device(s). AlphaPC 164UX PCI Ultra SCSI (Symbios Logic 53C875)". Press S. You will return to the list box of drives with other highlighted. Press ENTER. You will be prompted to "Please insert the disk labeled manufacturer supplied hardware support disk into drive A:. *Press enter when ready *." Make sure that the Windows NT 4.0 Install Floppy for the AlphaPC 164UX diskette is in drive A: and press ENTER. The list box of AlphaPC 164UX drivers will be displayed again. Highlight AlphaPC 164UX PCI IDE (ATAPI) and press ENTER. The next screen displayed will say "Setup will load support for the following device(s). AlphaPC 164UX PCI Ultra SCSI (Symbios Logic 53C875) and AlphaPC 164UX PCI IDE (ATAPI)". Press the ENTER key to continue with setup.
Setup will copy more files. Then it will initialize the kernel. This will be seen as a blue screen with AlphaPC 164UX in large letters on it. After this a screen titled "Welcome to Setup" will be displayed. Press ENTER.
The next screen will say "Setup has recognized the following mass storage devices in your computer." And it will display the drivers you selected off the Windows NT 4.0 Install Floppy for the AlphaPC 164UX diskette earlier. Press ENTER.