Bulletin | Karrykrimp 2 |
Trouble Shooting Guide |
|
|
|
If you have a problem with your Karrykrimp 2 machine... |
|
First, check that the proper tooling, hose and fitting combinations are being used. |
|
Then check the following recommendations. If after the following suggested remedy, the problem persists, call our Technical Service Department (440)
| SYMPTOMS | POSSIBLE CAUSES | WHAT TO DO | |
|
|
|
|
|
| Hand pump, air/hydraulic pump, |
| Refer to Enerpac instructions or | |
| electric pump, pump hose |
| call Enerpac at | |
| assembly, quick disconnect |
|
|
|
| problems. |
|
|
|
| Coupling crimp diameter above | Wrong fitting style being used. | Only approved fittings can | |
| or below specification. |
| be used with Karrykrimp 2 | |
|
|
| machine. For a complete | |
|
|
| selection and correct | |
|
|
| combinations of hose and | |
|
|
| fittings, see Catalog 4400. |
|
|
| Wrong hose being used. | Only approved hoses can | |
|
|
| be used with Karrykrimp 2 | |
|
|
| machine. For a complete | |
|
|
| selection and correct | |
|
|
| combinations of hose and | |
|
|
| fittings, see Catalog 4400. |
|
|
| Wrong die ring being used. | Refer to die selection chart or | |
|
|
| Catalog 4400 for correct die | |
|
|
| ring. |
|
|
| Pusher is not being bottomed | Lubricate die cavity with Citgo | |
|
| out on die ring and base plate | MP Lithoplex lithium grease | |
|
| completely (usually inconsistant | or equivalent. Bottom out | |
|
| crimp diameters). | the pusher on the die ring | |
|
|
| completely. Can also check for | |
|
|
| proper bottoming by placing | |
|
|
| a piece of paper between die | |
|
|
| ring and base plate. If properly | |
|
|
| bottomed, should not be able to | |
|
|
| remove paper. |
|
|
| Pump relief valve set too low. | Adjust relief valve setting to | |
|
|
| 10,000 psi. |
|
|
| High or low voltage. | Call a qualified electrician. |
|
|
| Low on oil. | Refill oil reservoir with Enerpac | |
|
|
| oil. | |
12 | Parker Hannifin Corporation |
| Hose Products Division |
Wickliffe, OH